N7201A618E00_0309.pdf - 第251页

NPM–W 2 EJM7DE-MB-02 -1T-00 IspBox MainSys LNB connection err or IspBox MainSys Inspector head communic ation error IspBox MainSys Hardware abnormal IspBox MainSys Snsr calibra tion Taken pic ture save error Solutions to…

100%1 / 338
NPM–W2 EJM7DE-MB-02-1T-00
IspBox MainSys Snsr
calibration Distortion
correction error
IspBox MainSys Snsr
calibration Light measure
error
IspBox MainSys Snsr
calibration Correction post
recog error
IspBox MainSys Whole
board image save error
Error
Message
Troubleshooting
2-1-4
Emergency stop errors
41
Error Code
Error Message
Cause Inspection and Solution
Image could not be saved
properly.
(Failed to save the image.)
Check the available hard disk space.
1881
Calibration post could not be
recognized properly.
(Failed to recognize
calibration post.)
Clean the calibration post.
1882
Brightness of the jig could
not be measured properly.
(Failed to measure the
brightness of jig.)
Clean the jig.
1883
Distortion could not be
corrected properly.
(Failed to correct distortion.)
Clean the jig.
1884
2-1-4-81
NPM–W2 EJM7DE-MB-02-1T-00
IspBox MainSys LNB
connection error
IspBox MainSys Inspector
head communication error
IspBox MainSys Hardware
abnormal
IspBox MainSys Snsr
calibration Taken picture
save error
Solutions to errors
Error Code
Error Message
Cause Inspection and Solution
Captured image could not be
saved properly.
(Failed to save captured
image.)
Check the network connection. Then,
restart the machine.
1885
Malfunction of hardware was
detected.
(Hardware malfunction
detected.)
Replace the failed component of the
hardware. Contact PFSC.
1886
Command to the camera
failed to be sent properly.
(Failed to set camera gain.)
Restart the machine. If the error
persists, contact PFSC.
1887
Communication with LNB
failed.
(Failed to establish
communication with LNB.)
Check the network connection. Then,
restart the machine.
1888
2-1-4-82
NPM–W2 EJM7DE-MB-02-1T-00
IspBox MainSys Inspector
box initialization error
IspBox MainSys Hard disk
capacity not enough error
IspBox MainSys Make the
LNB work folder error
IspBox MainSys Machine
command Initialization
command error
Error
Message
Troubleshooting
2-1-4
Emergency stop errors
42
Error Code
Error Message
Cause Inspection and Solution
Initial commands were sent
more than once from the
machine.
(Multiple initialization
commands received from
machine.)
Restart the machine.
1889
Work folder for LNB could
not be created.
(Failed to create LNB work
folder.)
Check the network connection. Then,
restart the machine.
1890
Hard disk space is
insufficient.
(Insufficient hard disk space)
Check the available hard disk space.
1891
Invalid head type
(Unsupported head type was
notified.)
After turning OFF the machine
power, check the mounted head. If
the error persists, contact PFSC.
1892
2-1-4-83