3OM-1075-002.pdf - 第290页
2.1.7.2 "P .E.C. Recog Brightness" T ab This tab sheet must be used only by our service personnel. It is not required to enter any parameters because they are automati- cally taught. • Sheet Layout When the &qu…
Fixed camera B1 Brightness (Back Lighting #1 through #4,
Front Lighting (Upper) #1 through #4, Front Lighting (Center
#1 through #4), and Front Lighting (Lower))
The specified parameters are used for the component recognition
in which the lighting unit on the main machine is used.
The machine is provided with the lighting units (back and front light-
ing systems). The lighting units for the back lighting system are lo-
cated above those for the front lighting system.
These brightness values must be determined such that almost the
same brightness (shades of gray) is obtained for each LED (used
for component recognition operations).
"0" (zero) means the darkest and "256" the brightest.
0206-002 5-57
AHB01EDTP
2.1 "Offset Data" Tab
2.1.7.2 "P.E.C. Recog Brightness" Tab
This tab sheet must be used only by our service personnel.
It is not required to enter any parameters because they are automati-
cally taught.
• Sheet Layout
When the "P.E.C. Recog Brightness" tab is pressed in the "Bright-
ness" tab sheet, the following tab sheet appears.
Fig. 3E56 "P.E.C. Recog Brightness" Tab Sheet
• Sheet Composition
*1 Offset Items
Set the following offset values.
P.E.C. recog camera P1 and P2 Brightness (Standard and Ce-
ramic)
The specified parameters are used for the P.C.B. recognition in which
the lighting unit on the beam is used.
There are two P.E.C. recognition cameras - P1 and P2.
Set the brightness values of the LEDs such that the optimum bright-
ness (shades of gray) is obtained for P.C.B. recognition operations.
"0" (zero) means the darkest and "256" the brightest.
2.1 "Offset Data" Tab
0308-003 5-58 AHB01EDTP
*1
2.1.7.3 "Offset Teaching Brightness" Tab
This tab sheet must be used only by our service personnel.
It is not required to enter any parameters because they are automati-
cally taught.
• Sheet Layout
When the "Offset Teaching Brightness" tab is pressed in the "Bright-
ness" tab sheet, the following tab sheet appears.
Fig. 3E57 "Offset Teaching Brightness" Tab Sheet
• Sheet Composition
*1 Offset Items
Set the following offset values.
Offset teaching brightness
The specified parameter is used for the component recognition cam-
era offset teaching operation in which the lighting unit on the main
machine is used.
The brightness value (based on the reflection of light emitted from
the lighting unit for the offset teaching operation) is determined
through the automatic teaching operation.
The brightness value is specified such that the optimum brightness
is obtained.
"0" (zero) means the darkest and "256" the brightest.
0308-003 5-59
AHB01EDTP
*1
2.1 "Offset Data" Tab