operation-cp45.pdf - 第104页
Samsung Component Placer CP-45F(V)/FS Operations Manual 4-2 4.2. Feeder Unlock Sensor Feeder unlock sensors are installed at the front and rear of this equipment. The system comes into the emergency stop status if the fe…
Sensor Detection Functions
4-1
Chapter 4. Sensor Detection Functions
4.1. Door Switch
Door switches for detecting the opening/closing status of the front and rear doors are
attached to this equipment respectively. The door switch is integrated with a magnet and a
door opening/closing sensor.
(CE Option) (Normal)
Figure 4-1. Door Switch
If the door is open while this equipment is running, the door switch is activated and the
system comes into the emergency stop status. The emergency stop status is released if the
door is closed. In order to resume the operation, press <Stop> and <Reset> switch on the
operation panel to release the emergency status, then press <Main Start> and <Ready>
switch.
Warning
If the safety sensor of the door is cancelled arbitrarily, the
machine will not stop even though the door is opened during
operation, which could cause injury.
The safety sensor of the door must not be cancelled
arbitrarily.
Samsung Component Placer CP-45F(V)/FS Operations Manual
4-2
4.2. Feeder Unlock Sensor
Feeder unlock sensors are installed at the front and rear of this equipment. The system
comes into the emergency stop status if the feeder is not installed correctly at the feeder
base. In this case, verify that the feeder is installed properly.
4.3. Up/Down of Backup Table
1. Select <Diagnosis> from the MMI main menu tool-bar, and select “<I/O>(F2)” from
the sub menu tool-bar on the left displayed.
“I/O Status” dialog box is shown on the screen.
Figure 4-2. “Manual Control” dialog box
2. In order to move the back-up table, double-click on the <But Up/Down> in the
<Output> list box, or click on the adjacent round button.
Caution
If the feeder loose sensor is cancelled arbitrarily, the head
and the feeder might collide as a loose feeder cannot be
sensed.
Do not cancel the feeder loose sensor arbitrarily.
Operational procedure
Sensor Detection Functions
4-3
3. The back-up table is moved up and down following the selection of <But Up/Down>
button. Up/Down can be performed by selecting the Up/Down item from the list and
then repeatedly pressing the space key.
4.4. Up/Down of Place Stopper
1. Select <Diagnosis> from the MMI main menu tool-bar, and select “<I/O>(F2)” from
the sub menu tool-bar on the left displayed.
“I/O Status” dialog box is shown on the screen. If the box is already shown, it is not
necessary to do it again.
Figure 4-3. “Manual Control” dialog box
2. In order to move the place stopper, double-click on the <Place Stop. U/D> button in
the <Output> list box, or click on the adjacent round button at the side.
3. The ing stopper is moved up and down following the selection of <Place Stop. U/D>
Caution
Be sure to remove any foreign substance on the BUT and
obstruction before manipulating the BUT.
Otherwise, the conveyor might be damaged.
Operational procedure