operation-cp45.pdf - 第315页
Sys.Setup Command 15-29 Figur e 15-16. “ Sys. Setup : Standar d Device – Stick ” di alog box <1. Stick T ype> list box Select the stick feeder type to set. <2. Default Feed T ime> edit box Set the feed ti…
Samsung Component Placer CP-45F(V)/FS Operations Manual
15-28
R2R1SlotL1L2
피
더
<4. Timing – Open Time> edit box
Time needed to open the shutter of the tape feeder.
<4. Timing – Feeding Time> edit box
Time needed to feed the tape feeder.
<5. Pickup Offset - X> edit box
Set the X offset value of the pickups point position of the tape feeder.
Based on the setting of the tape feeder in the front of the equipment, set the offset
value of the pickups point of other feeders against the pickups point of the 8mm tape
feeder.
<5. Pickup Offset - Y> edit box
Set the Y offset value of the pickups point position of the tape feeder.
<5. Pickup Offset - Z> edit box
Set the Z offset value of the pickups point position of the tape feeder.
<6. Width - Left> edit box
Set the left width of the tape feeder.
<6. Width - Right> edit box
Set the right width of the tape feeder.
Next screen is the case where the “Stick” is selected in the Device list.
Set the data on the stick feeder.
FEEDER
Sys.Setup Command
15-29
Figure 15-16. “Sys. Setup : Standard Device – Stick” dialog box
<1. Stick Type> list box
Select the stick feeder type to set.
<2. Default Feed Time> edit box
Set the feed time.
<3. Width – Left> edit box
Set the left width of the stick feeder.
<3. Width – Right> edit box
Set the right width of the stick feeder.
Next screen is the case where the “Tray” is selected in the Device list.
Set the data on the tray feeder.
Samsung Component Placer CP-45F(V)/FS Operations Manual
15-30
Figure 15-17. “Sys. Setup : Standard Device – Tray” dialog
<1. Tray Type> list box
Select the tray feeder type to set.
<2. Default Step> edit box
Tray Feeder Type 에 따른 각 TrayFeeder 들의 기본 Tray 수를 설정합니다:
Single Tray(5)FW-20F(20), FW-20S(20), FW-12M(12), FW-24XS(24).
<3. Width> edit box
Set the width of the tray feeder.
Next screen is the case where the “Nozzle” is selected in the Device list.
Set the data on Nozzle.