operation-cp45.pdf - 第62页
Samsung Component Placer CP-45F(V)/FS Operations Manual 2-10 This installs a back-up pin for maintain ing the evenness of a PCB, and drives the PCB clamp, hole fixer, etc., prior to the be ginning of work after the PCB h…
Basic Configuration and Name of Each Part
2-9
Width adjustment part
Adjusts the width of rails according to the size of PCB. It is composed of LM guide,
lead screw, chain, handle.
P
CB belt assembly
Composed of an AC (step) motor and a timing belt. For a 3-stage conveyor, PCB feed
belt is divided into three steps, and each is driven separately. For a 3-stage conveyor,
a PCB can be clamped by using a belt in the working area since in and out movement
of the PCB is possible without having to drive the belt in the working area.
Place stopper
Stops a PCB at a working position and hold the PCB in place until discharge if it is at
an out position.
PCB sensor
Checks the position of a PCB on the conveyor..
Edge fixer
This is one way of correcting the position of a PCB prior to the beginning of work
after the PCB has reached the working position. The correction is made in reference
to one side of the PCB by pushing into that edge.
PCB clamp
Holds a PCB that is in contact with the belt prior to the beginning of work after the
PCB has reached the working position. It is operated while interlocked with a back-
up table.
Hole fixer
This is another way of correcting the position of a PCB prior to the beginning of work
after the PCB has reached the working position. The correction is made in reference
to a hole in the PCB by inserting a pin into that hole. The hole fixer is operated while
interlocked with a back-up table.
Backup Table (BUT)
Caution
Adjusting the conveyor width without checking conveyor
obstruction or the existence of foreign substance could
damage the conveyor.
Be sure to check conveyor obstruction and the existence
of foreign substance before adjusting the conveyor width.
Samsung Component Placer CP-45F(V)/FS Operations Manual
2-10
This installs a back-up pin for maintaining the evenness of a PCB, and drives the
PCB clamp, hole fixer, etc., prior to the beginning of work after the PCB has reached
the working position.
Caution
Be sure to remove any foreign substance on the BUT and
obstruction before manipulating the BUT.
Otherwise, the conveyor might be damaged.
Basic Configuration and Name of Each Part
2-11
2.7. Board Specifications
2.7.1. PCB sizes, allowable deflection error
PCB Sizes
Minimum
3-stage Conveyor: 50.0mm (x-axis) × 30.0mm (y-axis)
Maximum
460.0mm (x-axis) × 400.0mm (y-axis)
510.0mm (x-axis) x 460.0mm (y-axis) – Factory Option
PCB Thickness
Minimum
3-stage Conveyor: 0.38mm
Maximum: 4.0mm
Allowable deflection error
2.0mm (while fixed to the placement area)