operation-cp45.pdf - 第229页
PCB Edit Command 1 1-75 Figur e 1 1-47.. “ Feeder : Feeder Base ” dialog box <Unit> group Select the feeder base unit to edit. button selects the previous unit, button selects the next unit. <1. Feeder Base&…
Samsung Component Placer CP-45F(V)/FS Operations Manual
11-74
Removes the balls in the selected area.
When the balls in the selected area are removed, the screen looks as follows.
Figure 11-46 “Ball Gap of BGA components-when the balls in the selected area are
removed” dialog box
<OK> button
Saves the set ball gap status and closes the dialog box.
<Cancel> button
Closes the dialog box without saving the set ball gap status.
11.2. Feeder [F4]
The <Feeder> command edits data related to tape feeder, stick feeder, and tray feeder.
The user can specify the part to be installed on each feeder, teach pickups position, and
test component pickups. When this command is selected, the initial screen is for the tape
feeder screen.
11.2.1. Feeder Base
When the feeder base is selected, the following dialog box is displayed and the data on
feeder base can be edited.
PCB Edit Command
11-75
Figure 11-47.. “Feeder : Feeder Base” dialog box
<Unit> group
Select the feeder base unit to edit.
button selects the previous unit, button selects the next unit.
<1. Feeder Base> group
Display the status of various devices installed on the feeder base including the feeder
type and edit the installation position.
<No> column
A serial number of the feeder base slot. Air pressure type feeder base has 52 slots.
<Part> column
Samsung Component Placer CP-45F(V)/FS Operations Manual
11-76
Select the component to install in the corresponding slot. When the <Part>
column is clicked on, the combo box appears, and of the components registered
in <1.2 Part>, the list of components to be supplied to “Tape” is displayed. Select
the component to install in this list. Next is the screen that shows selection of
components in the combo box of <Part> column.
Figure 11-48. “Feeder : When the part is selected in the Feeder Base” screen
<Type> column
Displays the type of the device installed in the corresponding slot. Next screen
shows the content displayed in the <Type> column of the feeder base on which
various devices are installed.
Figure 11-49. “Feeder : When various devices are installed in the Feeder Base” screen