operation-cp45.pdf - 第82页
Samsung Component Placer CP-45F(V)/FS Operations Manual 2-30 2.15. Component Supply Feeders This is a device for supplying components to the equipment during operation. It includes tape feeder, stick feeder, multi-tray f…
Basic Configuration and Name of Each Part
2-29
2.14. Feeder Station Part
Components can be supplied during operation by placing the component supply
device on the feeder base. The part can be used by installing ANC, tape feeder, stick
feeder, and stack stick feeder, and on the rear side single-tray feeder and multi-tray
feeder can be installed.
The ANC, air pressure supply coupling for the stack stick feeder, and power
connector are situated on the connector panel at the front side.
Figure 2-19. Feeder Station Part
Speed control of a multi-cylinder is possible since a speed control valve is protruded. The
multi-cylinder (feeder driving cylinder) is located at the lower side of the feeder base, and
is a multiple-drive cylinder driving the lever of a feeder by the piston load.
The both end slot of the front and rear feeder base (mechanical: number 1 and 52;
electrical: number 1 and 76), only the 8mm tape feeders are available.
Caution
If the nut is not locked after adjusting the Speed Control
Valve, the speed might change.
Be sure to lock the nut after adjusting the Speed Control
Valve.
Connector panel
Feeder base
Speed control valve
Memo
Samsung Component Placer CP-45F(V)/FS Operations Manual
2-30
2.15. Component Supply Feeders
This is a device for supplying components to the equipment during operation. It includes
tape feeder, stick feeder, multi-tray feeder, single-tray feeder, and vibration feeder.
Caution
Manipulating the feeder without getting thoroughly familiar
with the feeder manual could result in feeder damage or
personal injury.
Be sure to get thoroughly familiar with each feeder manual
before manipulating the feeder.
Basic Configuration and Name of Each Part
2-31
2.15.1. Tape feeder
There are eight tape feeder types including customized feeder for 1005 chip, 8mm, 12mm,
16mm, 24mm, 32mm, 44mm, and 56mm.
1 Pusher Lever 9 Clamp Lever
2 Location Pin 10 Manual Lever
3 Locker 11 Pawl Lever
4 Ratchet 12 Planet Lever
5 Sprocket 13 Planet Gear
6 Buck Up 14 Take Up Reel
7 Shutter 15 Reel Arm Post
8 Tape Guide 16 Planet Lever Spring
Figure 2-20. Tape Feeder
Based on 8.0mm tape feeder, total of 104 feeders, 52 feeders each at the front and
rear side, can be ed.
8.0mm tape feeder is used exclusively for the 1005 chip.
Memo