operation-cp45.pdf - 第140页

在线预览 operation-cp45.pdf PDF 文档。

File Commands

8-9

8.6. Exit [Alt+F4]

Use the <Exit> command to end an MMI application session. When the <Exit> command

is selected, any MMI session is terminated. This command can be used only on the MMI

main screen. If there are any window that are currently open, the following dialog box is

displayed. Just click on the <OK> button and close all the windows and then execute the

<Exit> command.

Caution

System needs to be shut down after normally ending the MMI,

otherwise, the machine might be damaged and injury could

occur due to system error caused by irregular shut down. Be

sure to shut down the system after normally ending the MMI.

View Commands

9-1

Chapter 9. View Commands

The <View> command is composed of the six submenus: Manual Tool, Current Position,

System Error Message, Dump Information, Tool bar Position, Mark3TSG.

When a submenu of <View> command is selected, check mark() appears in front of the

submenu (except for some commands), and the corresponding message box is displayed

on the main screen. If the menu is selected again, the check mark disappears and the

corresponding message box also closed.

Figure 9-1. View Menu and Submenus

9.1. Manual Tool

Executes a manual operation of the equipment. When this command is selected, the

following dialog box is displayed.

9.1.1. Axis Moving Dialog Box

Used to move or to read in the current position of each axis.