operation-cp45.pdf - 第194页
Samsung Component Placer CP-45F(V)/FS Operations Manual 11-40 Figur e 1 1-27. . “ Auto T each the selected part-Bad ” message box The same as the Figure 1 1-28, but the <Update> button is inactivated. <Repeat……
PCB Edit Command
11-39
Figure 11-26.”Auto Teach the selected part-Good” message box
<Result>
Displays the success or failure of Auto Teach.
<Auto Teach> button
Executes Auto Teach.
<Update> button
Saves the component align data obtained by Auto Teach and closes the message
box.
<Cancel> button
Closes the message box without saving the data obtained by Auto Teach.
When Auto Teach fails, the following message box is displayed.
Samsung Component Placer CP-45F(V)/FS Operations Manual
11-40
Figure 11-27. . “Auto Teach the selected part-Bad” message box
The same as the Figure 11-28, but the <Update> button is inactivated.
<Repeat…> button
Performs the component recognition test repeatedly. It is not explained here since it is
for debugging.
11.1.2. CHIP-Rect component data setting
Set the align data for rectangular CHIP components.
PCB Edit Command
11-41
Figure 11-28. “Align Type = Vision, Package Group = CHIP-Rect” dialog box
<Camera No.> combo box
Select the camera to recognize the component.
<Light Control> button
Select the light for the camera to recognize the component.
<Size> group
Set the align size.
<Body X> edit box
Set the component size in X direction.
<Body Y> edit box
Set the component size in Y direction.
<Lead W> edit box
Set the length of lead in X direction.
<Lead L> edit box
Set the length of lead in Y direction.
<Align Z> edit box
Set the height for recognition. Based on the component surface, if the top is to be
recognized, set - value and if the bottom is to be recognized, set + value.
<Threshold> edit box
When there is a pre-treatment process for component recognition and the gray
level image is converted into binary, it is the value used as the criteria to
determine black and white.
The value range is 0 – 255(0: black, 255: white), and this value serves to
differentiate the component from the background. When the set value is 0, the
value is set automatically during component recognition.
<Auto> check box