operation-cp45.pdf - 第92页

Samsung Component Placer CP-45F(V)/FS Operations Manual 3-2 stage, power is not turned on for the dr ivers such as motor. The power should be turned off only after terminating t he MMI. If the power is suddenly turned of…

Panel Operations

3-1

Chapter 3. Panel Operations

3.1. Switching of Operation Panel

Figure 3-1. Operation Panel

witching operation on the operation panel is described below:



<Isolation> switch

Has a function of supplying or stopping the main power to the equipment. Power is

supplied to a controller by turning the switch. A power lamp is lighted and a working

screen is shown on the programming monitor after a short delay. During the initial

Warning

Pressing the Start switch without checking the presence

of worker nearby could cause injury. Be sure to check if

there is any worker near the machine before pressing the

Start switch.

Buzze

Emergency switch

Ready switch

Start switch

Stop switch

Reset switch

Front Feeder CHG. switch

Main start switch

Isolation switch

Samsung Component Placer CP-45F(V)/FS Operations Manual

3-2

stage, power is not turned on for the drivers such as motor. The power should be

turned off only after terminating the MMI. If the power is suddenly turned off, the

data and the main body may be damaged and the equipment malfunction may occur

at the next power up.



in start> switch

Power is supplied by first pressing the green switch of a main start switch in order to

supply power to the power systems such as a motor. To cut off the power supply,

press the red switch.



<Ready> switch

This is a switch for initiating the operation of this equipment. The power is supplied

to the driving systems such as motor. It is used to put the equipment into the standby

status after power-up. <EMG (emergency stop)> switch can be pressed to release the

standby state.



<Start> switch

This is a switch for initiating the operation of this equipment. Automatic operation is

initiated if this switch is pressed.

This switch can be activated for the following cases:



Temporary stop status of operation by <Stop> switch during automatic operation.



Error stop status that can be restarted.



<Stop> switch

This is a switch for temporary stopping of the operation. Automatic operation of this

equipment is temporarily stopped if this switch is pressed. If this switch is pressed

while the placement is in progress, the operation is stopped after the present operation

is completed. This switch can also be used for turning off alarm sound due to an error.



<Reset> switch

Warning

If power supply is cut off suddenly, it could result in the

damage of data and machine.

And the machine might be damaged due to abnormal

operation when power is supplied again.

Before turning off power, be sure to end the MMI, turn

off the isolation switch, then turn on the isolation switch

after 5-10 seconds.

Panel Operations

3-3

This is a switch for terminating the operation of this equipment. Automatic operation

of this equipment is forcefully terminated if this switch is pressed. This switch is used

for deactivating either temporary stop status that had been activated by pressing the

<Stop> switch or the stop status due to an error. The <Reset> switch cannot be

activated during automatic operation of this equipment.



EMG (Emergency Stop) switch

This is an emergency stop switch. Operation of this equipment is immediately

suspended if this switch is pressed in case of an emergency. Supply of all powers

except for the power to a computer is ceased. The emergency stop status can be

released by turning the <EMG> switch in the direction of the arrow and pressing the

<Stop> and <Reset> switch.