operation-cp45.pdf - 第64页

Samsung Component Placer CP-45F(V)/FS Operations Manual 2-12 The sizes of PCB applicable for this equipment are as follows.  Front side conveyor fixed Max: 460L×400W×4.2H [ mm ] 510.0mm (x-axis) x 460.0m m (y-axis) – Fa…

100%1 / 324
Basic Configuration and Name of Each Part
2-11
2.7. Board Specifications
2.7.1. PCB sizes, allowable deflection error
PCB Sizes
Minimum
3-stage Conveyor: 50.0mm (x-axis) × 30.0mm (y-axis)
Maximum
460.0mm (x-axis) × 400.0mm (y-axis)
510.0mm (x-axis) x 460.0mm (y-axis) – Factory Option
PCB Thickness
Minimum
3-stage Conveyor: 0.38mm
Maximum: 4.0mm
Allowable deflection error
2.0mm (while fixed to the placement area)
Samsung Component Placer CP-45F(V)/FS Operations Manual
2-12
The sizes of PCB applicable for this equipment are as follows.
Front side conveyor fixed
Max: 460L×400W×4.2H [ mm ]
510.0mm (x-axis) x 460.0mm (y-axis) – Factory Option
Min: 50L×50W×0.38H [ mm ]
The maximum PCB size could differ according to the options.
20 stages Tray Feeder : 460 × 350 (2Tray / 1Pallet) , 460 × 400 (1Tray / 1Pallet)
24 stages Tray Feeder : 460 × 300 (1Tray / 1Pallet)
Rear side conveyor fixed
Max: 410L×360W×4.2H [ mm ]
Min: 50L×50W×0.38H [ mm ]
The maximum PCB size could differ according to the options.
20 stages Tray Feeder : 460 × 300 less
24 stages Tray Feeder : 460 × 270 less
2.7.2. PCB conveyor system height
Standard: 900.0mm ± 20.0mm
Semi-Standard: 952.50mm ± 12.5mm
For inquiries on PCB conveyor system height other than that listed above, please
contact our Business Department or C/S Center.
2.7.3. Conveyor rail width controller
Standard: Manual Control
Optional : Automation Control
2.7.4. Conveyor Regulator Pressure Setting
0.38t ~ 1.5t = 1.0kg / cm
2
(0.1Mpa)
1.5t ~ 4t = 2.0kg / cm
2
(0.1Mpa)
Note
Basic Configuration and Name of Each Part
2-13
2.7.5. Conditions for PCB
Figure 2-9. Conditions for PCB Limit
There is a 4.75mm extra spacing at the edge of the board. The upper margin is 17mm,
while the lower margin is 14.5mm. The board is supported by using a back-up pin with
135mm height.
PCB fixing method
The CP-45F/V and CP-45FS fixes PCB's with a position-fixing pin. Another method
of fixing the side of PCB's can also be selected, and a combination of the above two
methods is possible.
The present specifications should be adjusted at the time of delivery.
PCB transport direction and the position of a position-fixing pin
It is possible to transfer PCB from left to right or vice versa. It is desirable that the
user request for our assistance for switching the transport direction.
The position of a fixing pin can be arbitrarily designated by the user. The PCB
transport direction and the position of a fixing pin can be set as desired by the user at
the time of delivery.