CM602all_EJM8AESM_Service Manual.pdf - 第1032页

the bolt shown with the arrow below. Direct Tray Tray 2 1 section. Loosen the power locks on the motor Move the extension-axis towards you 382.5 mm. Left. Stay at the front side when removing Remark When loosening, use a…

100%1 / 1093
7-2-7
Part Weight
Min. Min.
Tray
Extension-axis Stroke Adjustment
• This section describes the procedures for adjusting the extension-axis stroke.
Total
Phillips screwdriver #2
Allen key 2.5 mm
Allen key 4 mm
Teaching
Removal/Disassembly
Direct Tray
Min.
kgs.
0
Min.
Tool
Jig
Assembly/Adjustment
Jig FM-1924
Pulley-holding jig
Caution
Danger
Warning
EJM8A-E-SMA070207-A01-00
Page 7-2-7-1
the bolt shown with the arrow below.
Direct TrayTray
2
1
section.
Loosen the power locks on the motor
Move the extension-axis towards you 382.5 mm.
Left. Stay at the front side when removing
Remark
When loosening, use an Allen key and screws
as shown below so that the power locks will
not be moved.
After loosening, lightly hitting the power locks
unlocks the lock. Jig available (right picture)
Item
Phillips screwdriver #2
M4 screw 11 pcs.
3
4
Open the cover.
Return the extension-axis to the origin.
Allen key 4 mm
Screw M5 4 pcs.
Right
436.5
Screw M5×40
Allen key
EJM8A-E-SMA070207-A01-00
Page 7-2-7-2
Tray
Tighten the motor power locks with a torque
wrench. Tightening torque: 9.8N•m
After tightening, the bearing should be
turned manually. Remove the jig.
Position the dog slit at the extension position.
Position the bearing with the jig.
How to set the jig (right picture)
The dowel pin of the jig should be inside of the LM.
The hollow on the rear side of the jig should be on the
LM.
Torque wrench 9.8 N•m
Allen key 4 mm
M5 screw 4 pcs.
Jig: FM-1924
Item
5
Remark
Inch the jig gradually with a 0.05-mm pitch.
Allen key 2.5 mm
M3 screw 2 pcs.
See the followings.
Section 7-2-2 Direct Tray
Pickup Position Teaching
Section 7-2-3 Magazine
Shutter Stopper Position
8
Carry out pickup position teaching.
Position the magazine stopper.
6
7
Direct Tray
A=382.5mm
Origin point
E
C
D
(392.5)
6
F
Magazine
(2)
(51)
Su
pp
l
y
section
B=9
(Magazine side)
Optical-axis
(Pickup side)
Dog
Extension-position sensor PH732
EJM8A-E-SMA070207-A01-00
Page 7-2-7-3