CM602all_EJM8AESM_Service Manual.pdf - 第1057页
19 Carry out pickup position teaching. Rear Phillips screwdriver #2 Screw M4 4 to 6 pcs. 20 Put the cover back on. See the followings: Section 7-2-2 Direct Tray Pickup Position Teaching Section 7-2-3 Magazine Shutter Sto…
,
14
16
Position the bearing with the jig.
How to set the jig (right picture)
Jig: FM-1924
The dowel pin of the jig should be inside of the LM,
and the hollow of the rear side of the jig should be on
the LM.
15
Move the extension axis towards you
382.5 mm.
Return the extension-axis to the origin.
Item Remark
13
Turn on the power.
Since the cover is open,
no one but the adjuster is
allowed to work on the
machine.
Tray Direct Tray
436.5
A=382.5
Origin
E
C
D
(
392.5
)
6
F
Magazine
(2)
(51)
Supply section
B=9
EJM8A-E-SMA070210-A01-00
Page 7-2-10-5
19
Carry out pickup position teaching.
Rear
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
20
Put the cover back on.
See the followings:
Section 7-2-2 Direct Tray
Pickup Position Teaching
Section 7-2-3 Magazine
Shutter Stopper Position
Adjustment
18
Position the dog slit at the extension-axis
position. Move the axis with a 0.1-mm pitch.
Allen key 2.5 mm
M3 screw 2 pcs.
Position the magazine stopper.
17
Torque wrench 9.8 N•m
Allen key 4 mm
M5 screw 4 pcs.
Tighten the motor power locks with a torque
wrench. Tightening torque: 9.8N•m
After tightening, the bearing should be
turned manually. Remove the jig.
Tray Direct Tray
Item Remark
Magazine side
(0.5 mm)
Lift side
(1.0 mm)
Optical-axis sensor
Extension position PH sensor PH732
Dog
Supply section
Light through: ON
Light blocked: OFF
Light blocked at the mechanical stopper
in the - (supply) direction
EJM8A-E-SMA070210-A01-00
Page 7-2-10-6
the bolt shown with the arrow below.
22
Remove the cover.
Tray
23
Close the cover.
Left. Stay at the front side when tightening Right
Phillips screwdriver #2
Screw M4 11 pcs.
Remove the bolt.
Rear
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
21
Put the cover back on.
Left Right
Phillips screwdriver #2
Screw M4 14 pcs.
Direct Tray
Item Remark
EJM8A-E-SMA070210-A01-00
Page 7-2-10-7