CM602all_EJM8AESM_Service Manual.pdf - 第393页
・ Tools ・ Jig Phillips screwdriver #2 Allen key 2.5 mm None Board Holder Unit This section describes the procedures for replacing the sensor for the ascent of the support-pin plate box. 5-2-3 Support-Pin Plate Box Ascent…
Item
Phillips screwdriver #2
Screw M4 2 pcs.
Tools and Specifications
Switch on the main power.
Tools and Specifications
Put the feeder cover back on.
Allen key 2.5 mm
Screw M3 2 pcs.
Replace the sensors.
8
7
6
5
Tools and Specifications
Place the cable in position and connect
Tools and Specifications
the connector.
Machinery Part Replacement Board Holder Unit
Remark
Lower limit
sensor
Upper limit
sensor
Do not loosen
EJM8A-E-SMA050202-A01-00
Page 5-2-2-3
・Tools
・Jig
Phillips screwdriver #2
Allen key 2.5 mm
None
Board Holder Unit
This section describes the procedures for replacing the sensor for the ascent of the support-pin plate box.
5-2-3
Support-Pin Plate Box Ascent Sensor Replacement
Machinery Part Replacement
min.
Weigh
t
o
f
Part
15 min. 20 min.
35
min
.
Kgs
.
Removal
Disassembly
A
ssembl
y
Adjustment
Teaching Total Time
Dange
r
Warning
Caution
EJM8A-E-SMA050203-A01-00
Page 5-2-3-1
Tools and Specifications
Tools and Specifications
Phillips screwdriver #2
Screw M4 2 pcs.
Remove the feeder cover
.
Switch off the main power and air supply.
Tools and Specifications
Tools and Specifications
Remove the connectors.
1
Item Remark
4
3
2
Pull the cable out of the duct.
Machinery Part Replacement Board Holder Unit
1
2
EJM8A-E-SMA050203-A01-00
Page 5-2-3-2