CM602all_EJM8AESM_Service Manual.pdf - 第957页
Tray Shuttle Tray Item Remarks 15 Move the extension axis towards you Return the extension-axis to the origin. 14 16 Position the bearing with the jig. Jig: FM-0982 by 436.5 stroke. 13 Power up the machine. This area sho…
After loosenin
g
, li
g
ht hit and remove
the lock.
Tray Shuttle Tray
Loosen the motor power lock.
10
11
12
Allen key 4 mm
Screw M5 4 pcs.
Connect thte motor connector.
Allen key 4 mm
Screw M5 2 pcs.
Item Remarks
Install the motor and tension the belt.
9
Combine the motor with the bracket.
Allen key 4 mm
Screw M5 4 pcs.
EJM8A-E-SMA070113-A01-00
Page 7-1-13-4
Tray Shuttle Tray
Item Remarks
15
Move the extension axis towards you
Return the extension-axis to the origin.
14
16
Position the bearing with the jig.
Jig: FM-0982
by 436.5 stroke.
13
Power up the machine.
This area should be for
servicemen only because
the cover is open.
A
=436.5st
Origin
E
CD
(454.5)
8
F
B=11.0
Whole shutter
(2)
(73)
436.5
EJM8A-E-SMA070113-A01-00
Page 7-1-13-5
Tray
20
Put the cover back on.
Phillips screwdriver #2
Screw M4 12 pcs.
19
Teach pickup position.
See Section "7-1-2. Shuttle
Tray Teaching."
18
Inch the dog by 0.1 mm.
Allen key 2.5 mm
Screw M3 2 pcs.
Precisely position the slit of the jig at the extension position.
17
Tighten the motor power lock.
Remove the jig.
Allen key 4 mm
Screw M5 4 pcs.
Item Remarks
Shuttle Tray
+
-
Magazine side
(0.5 mm)
Lift side
(1.0 mm)
Light-axis sensor
Extension position
PH sensor
Dog
EJM8A-E-SMA070113-A01-00
Page 7-1-13-6