CM602all_EJM8AESM_Service Manual.pdf - 第283页
治具基板挿入？ PT ﾃﾞｰﾀ無し ﾍｯﾄﾞﾊﾟｽ Maintenance Adjustment Press [Mount pos teach]. 20 18 19 Press [Yes]. Press [OK]. Press [ESC]. Press [Yes]. Press the "Unlock" and the "Start" keys. Press [Production]. (Moun…
Press the "Return" key. Press [Yes].
keys
15
14
ITEM
Maintenance Adjustment Light Transfer-Head Assembly(3 nozzles)
16
Pickup and recognition are
suspended and test run
starts.
Warm up the machine for
approximately 10 minutes
and press [Cycle stop] to
stop the machine.
Press [OK].
Press [Yes].
Press the "Unlock" and the "Start" Test Run screen
REMARKS
13
Press [Warmup operation].
Press [ESC].
EJM8A-E-SMA040307-A01-00
Page 4-3-7-6
治具基板挿入？
PTﾃﾞｰﾀ無し
ﾍｯﾄﾞﾊﾟｽ
Maintenance Adjustment
Press [Mount pos teach].
20
18
19
Press [Yes].
Press [OK].
Press [ESC].
Press [Yes]. Press the "Unlock" and the "Start" keys.
Press [Production]. (Mounting position Select the desired stage.
teaching)
ITEM REMARKS
Light Transfer-Head Assembly(3 nozzles)
17
EJM8A-E-SMA040307-A01-00
Page 4-3-7-7
Light Transfer-Head Assembly(3 nozzles)Maintenance Adjustment
23
Select the desired stage.
Press [Production]
24
(Accuracy Verification)
Remove the QFP jigs,
rotating them to avoid
breaking the QFP jigs.
After removing QFP jigs,
clean the double-sided
tape (Solvent can be
used.).
22
"Return" key.
After teaching is finished:
If cycle stop is carried out:
teaching is complete.
In case of immediate stop,
a head camera recognition
error has occurred and the
machine stopped; it is
necessary to teach again.
In case of half-way stop,
press "Unlock" and "Start"
to finish teaching, and re-
teach.
Remove the board.
Remove the chip jigs from the board.
Press [Yes].
Place the board jig. Once the machine stops, press the
ITEM REMARKS
21
"Immediate stop" and display the recognition screen
After waiting for the previous process, select
EJM8A-E-SMA040307-A01-00
Page 4-3-7-8