CM602all_EJM8AESM_Service Manual.pdf - 第218页
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles) Remarks Item Press [Unlock] and [PCB position tch] simultaneously. The head camera recognizes the jig hole so that the offset for the hole position will be …
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Place the board jig on the 2nd mounting position.
Firmly press the board jig against the
fixed guide and the board stopper.
Take care with the
orientation of the jig;
the hole on the jig should
face the stopper and the
fixed guide.
Press [Unlock] and [PCB position tch] simultaneously.
The head camera recognizes the jig hole
so that the offset for the hole position will
be entered automatically.
Press [Unlock] and [Jig adjust] simultaneously.
The head moves away. The board
stopper at the 1st mounting position
moves up.
Check that "Left" is
displayed on the "Jig
position" box of the
screen at left.
Set the board jig onto the first mounting position.
Firmly press the board jig against the
fixed guide and the board stopper.
Take care with the
orientation of the jig;
the hole on the jig should
face the stopper and the
fixed guide.
5
6
7
8
Stopper
Fixed side
ｽﾄｯﾊﾟｰ
固定側
Stopper
Fixed side
There should
be no gap.
There should
be no gap.
EJM8A-E-SMA040205-A01-00
Page 4-2-5-3
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press [Unlock] and [PCB position tch] simultaneously.
The head camera recognizes the jig hole
so that the offset for the hole position will
be entered automatically.
Press [Unlock] and [Mnt Height tch] simultaneously.
With the nozzle descending to and
ascending from the jig, the vacuum
pressure is measured and the offset is
set automatically.
Press [Unlock] and [Jig remove] simultaneously.
The head moves to the nozzle setting
position (over the NG box).
Remove the nozzle and
the jig.
Press the [Return] key.
To save the parameter,
press the [Return] key.
9
10
11
12
EJM8A-E-SMA040205-A01-00
Page 4-2-5-4
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press [Unlock] and [Run] simultaneously.
The X- and the Y-axes of the selected
stage return to the origin.
Press [PCB positioning Mount height].
Select the rear stage.
Press the "Unlock" key and [Jig setting] simultaneously.
Fit Nozzle 130 onto
Nozzle Position 3.
13
14
15
16
EJM8A-E-SMA040205-A01-00
Page 4-2-5-5