CM602all_EJM8AESM_Service Manual.pdf - 第301页

Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles) Remarks Item Setting Display value 2. Setting Input value 1. 7 8 Check that "DSP2" is displayed after Input value 2 is set. To set "09800,&qu…

100%1 / 1093
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
Remarks
Item
Press [Load Head].
The board width is set to 70 mm and the
conveyor width is adjusted automatically.
Press the "Unlock" key and [Jig setting]
Place the load cell jig.
simultaneously. The cable should not be
higher than the height of
the load cell.
Setting Input value 2.
4
5
6
Press several times until the
"SCALE" is displayed.
Press for 1 sec.
RESET/
TEACH
Place a 1-kg weight on the load cell.
Press for 1 sec.
RESET/
TEACH
Press again.
To determine, press
EJM8A-E-SMA040310-A01-00
Page4-3-10-3
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
Remarks
Item
Setting Display value 2.
Setting Input value 1.
7
8
Check that "DSP2" is displayed after
Input value 2 is set.
To set "09800," press
To determine, press
Check that "INP1" is displayed
after Display value 2 is set.
Re-press
RESET/
TEACH
To determine, press
Press to highlight the digit
to be changed.
RESET/
TEACH
Place a 100-g weight on the load cell.
Press for 1 sec.
EJM8A-E-SMA040310-A01-00
Page4-3-10-4
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
Remarks
Item
Setting Input value 1
Decimal Point Position
9
10
Check that "DSP1" is displayed
after Input value 1 is set.
Check that "DEC-P" is displayed
after Display value 1 is set.
Check the position of the decimal
point. To determine, press
ESC
Press several times until
the number is displayed.
Finish the setup.
Proceed to load coefficient teaching.
Pres s to highlight the digit
be changed.
To set "00980," press
To determine, press
Press to highlight the digit
to be changed.
EJM8A-E-SMA040310-A01-00
Page4-3-10-5