CM602all_EJM8AESM_Service Manual.pdf - 第680页
Maintenance Part Replacement 12-Nozzle Head Teaching Tools Ruler 500 mm Jig None 5-11-5 Conveyor-Width-Adjusting Axis Origin Offset Remove the support pins beforehand. This section describes the procedures for determinin…
Machinery Part Replacement
Remarks
Item
12-Nozzle Head Teaching
Press [Jig remove].
• Once teaching is finished, remove the
jig and the 5-hole jig from the holder.
• Fit the numbers 1 to 8 nozzles and
nozzle holders.
Press [Jig setting].
• '6' is displayed in the POS box below
the [Jig setting]. Put the 5-hole 12-nozzle
jig on the number 6 holder.
* Each time [Jig setting] is pressed, the
POS indication changes from 6, 5 to 4.
Press [Nzl anglOrgOffset].
• To teach the nozzle, press [Nzl angle
Org Offset].
* Once nozzle angle origin offset is
finished, press [Jig setting] above "POS"
and repeat the procedures until POS5
teaching is finished.
The angle offset for each nozzle
should be within +/-5.0°
Remove the jig.
• Once all teaching is finished, remove
the jig and the 5-hole jig from the holder.
• Fit the numbers 1 to 12 nozzles and
nozzle holders.
11
12
9
10
* If the value is outside the range,
carry out adjustment again.
EJM8A-E-SMA051104-A01-00
Page 5-11-4-4
Maintenance Part Replacement 12-Nozzle Head Teaching
Tools
Ruler 500 mm
Jig
None
5-11-5 Conveyor-Width-Adjusting Axis Origin Offset
Remove the support pins beforehand.
This section describes the procedures for determining the offset for the origin of the conveyor-width adjusting axis.
Caution Dange
r
Warning
EJM8A-E-SMA051105-A01-00
Page 5-11-5-1
Maintenance Part Replacement 12-Nozzle Head Teaching
Remarks
Press [W axis origin offset].
Select the desired stage.
Press [Unlock] and [Return to origin] simultaneously.
The width adjusting axis returns to the
origin.
Press [Unlock] and one of the arrow keys - [
↑] or [↓] - simultaneously.
Moving the width adjusting axis and
measuring the width of the conveyor with
a ruler, adjust the width to 460.5 mm.
Each time the [Key rsps] key is pressed,
the amount by which the axis moves is
changed from 0.01 mm to 0.1 mm to 1
mm.
Specifications:
460.5 mm + 0mm to
0.2mm
(460.5mm to 460.7mm)
1
Item
2
3
4
EJM8A-E-SMA051105-A01-00
Page 5-11-5-2