CM602all_EJM8AESM_Service Manual.pdf - 第389页
Put back the chute onto the rear 30 Tools and Specifications side of the selected stage. Allen key 4 mm Screw M5 4 pcs. Remark Machinery Part Replacement Board Holder Unit Item 29 Tools and Specifications Phillips screwd…
See "Leveling the Support Plate."
Item Remark
Machinery Part Replacement Board Holder Unit
25
Connect the cylinder air tubes.
Tools and Specifications
26
Supply power and air.
Check that the table is lowered.
Tools and Specifications
27
Level the support plate.
Tools and Specifications
Section 4-1-6
28
Put back the ceiling.
Tools and Specifications
Allen key 3 mm
Screw M4 4 pcs.
1
2
EJM8A-E-SMA050201-A01-00
Page 5-2-1-8
Put back the chute onto the rear
30
Tools and Specifications
side of the selected stage.
Allen key 4 mm
Screw M5 4 pcs.
Remark
Machinery Part Replacement Board Holder Unit
Item
29
Tools and Specifications
Phillips screwdriver #2
Round cross-head screw
M6 4 pcs.
Put back the lower cover onto the rear side of the selected stage.
Chute holding
section (Left)
Chute holding
section (Right)
EJM8A-E-SMA050201-A01-00
Page 5-2-1-9
Kgs
.
Total Time
Weight o
f
Part
15
min
.
Removal
Disassembl
y
A
ssembly
A
d
j
ustment
Teaching
min.7 min. 8 min.
・Tools
Machinery Part Replacement Board Holder Unit
This section describes the procedures for replacing the upper and the lower limit sensors for the support plate.
5-2-2
Support Plate Upper and Lower Limit Sensor Replacement
Phillips screwdriver #2
Allen key 2.5 mm
None
・Jig
Dange
r
Warning
Caution
EJM8A-E-SMA050202-A01-00
Page 5-2-2-1