CM602all_EJM8AESM_Service Manual.pdf - 第180页
Maintenance Adjustment Main Body Beam Remarks Item Adjust the clearance, hammering the fixed blade block. Hammer Allen key 4 mm Screw M5 9 pcs. Check the clearance. Specification: 0 to 0.02 mm Feeler gauge Tighten the sc…
Maintenance Adjustment Main Body Beam
Remarks
Remove the cutter unit.
See "Cutter Unit Replacement." Section 5-9-4
Check the clearance between the fixed and the movable cutter blades.
Record the current clearance.
Feeler gauge
Loosen the screws holding the fixed blade block
Allen key 4 mm
Screw M5 12 pcs.
Raising the fixed blade block, lightly tighten the screws.
Allen key 4 mm
Screw M5 9 pcs.
3
4
1
Item
2
Raise
Tighten lightly
EJM8A-E-SMA040112-A01-00
Page 4-1-12-2
Maintenance Adjustment Main Body Beam
Remarks
Item
Adjust the clearance, hammering the fixed blade block.
Hammer
Allen key 4 mm
Screw M5 9 pcs.
Check the clearance.
Specification:
0 to 0.02 mm
Feeler gauge
Tighten the screws holding the fixed balde block.
Allen key 4 mm
Screw M5 12 pcs.
Put back the cutter unit.
See "Cutter Unit Replacement." Section 5-9-4
5
6
7
8
Lowering the fixed cutter blade slowly,.
adjust the gap of the movable and the
fixed cutter blades.
If lower excessively, return to Step 4
and raise the cutter blade.
=Jig
0 to 0.02 mm
Fixed cutter blade
Movabel cutter blade
=Jig
Once adjustment
is finished, tighten.
EJM8A-E-SMA040112-A01-00
Page 4-1-12-3
Kgs.
R
emova
l
Disassembl
y
A
ssem
bly
A
d
j
ustment
Teaching
Total Time
W
e
i
g
ht
o
f
Part
min. 30 min.
30
m
i
n
.
min.
・Tools
・Jigs
None
None
Maintenance Adjustment Main Body Beam
・This section describes the procedures for adjusting the air pressure.
4-1-13 Air Pressure Adjustment
Caution
Dange
r
Warning
EJM8A-E-SMA040113-A01-00
Page 4-1-13-1