CM602all_EJM8AESM_Service Manual.pdf - 第593页

Machinery Part Replacement Remarks Switch off the main power and air supply. Remove the feeder cover and the chute. Phillips screwdriver #2 Allen key 3 mm Screw M4 2 pcs. Screw M4x10mm 3 pcs. Thick washer 3 pcs. Remove t…

100%1 / 1093
Machinery Part Replacement
・Tools
Phillips screwdriver #2
Allen key 3 mm
Allen key 5 mm
Pipe
Nipper
Dial gauge
Magnetic stand
Plate
・Jig
FM-0988
Cutting unit positioning jig
Cutting Unit
5-9-4　　　　　 Cutter Unit Replacement
This section describes the procedures for replacing the cutter unit.
・The cutter unit is heavy; remove with care.
・Don't touch the cutter blades. Otherwise you may cut your hand.
Assembly
A
d
j
ustment
25min.
Teaching
min.
Total　Time Weight　of
Part
Removal
Disassembl
y
20min.
45min.
40kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050904-A01-00
Page　5-9-4-1
Machinery Part Replacement
Remarks
Switch off the main power and air supply.
Remove the feeder cover and the chute.
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4x10mm 3 pcs.
Thick washer 3 pcs.
Remove the cylinder tubes to release air.
Since pressure is applied, pushing the
hose holding ring with a wrench or an
equivalent tool, remove the hose.
Magic marker
Air tube φ8　　4 pcs.
Remove the upper cutter cover.
Allen key 3 mm
Screw M4x8mm 5 pcs.
Cutting Unit
Item
2
3
1
4
1
2
EJM8A-E-SMA050904-A01-00
Page　5-9-4-2
Machinery Part Replacement
Remarks
Cutting Unit
Item
Remove the lower cutter cover.
Allen key 3 mm
Pipe
Screw M4x10mm 5 pcs
Cut the cable ties from the air tubes.
Nipper
Cable tie 100 6 pcs.
Close the movable cutter blade by hand.
Note: Do not touch the blade. Normally it is closed.
Remove the grease tube.
8
5
6
7
EJM8A-E-SMA050904-A01-00
Page　5-9-4-3