CM602all_EJM8AESM_Service Manual.pdf - 第388页
See "Leveling the Support Plate." Item Remark Machinery Part Replacement Board Holder Unit 25 Connect the cylinder air tubes. Tools and Specifications 26 Supply power and air. Check that the table is lowered. T…
Tighten screws holding the support-plate upper-limit determining bars.
21
Remove the bar from the support-plate upper-limit determining bar
24
Remove the block.
Tools and Specifications
Allen key 5mm
Screw M3 6 pcs.
Tools and Specifications
Allen key 2.5 mm
Screw M3 6 pcs.
The dog and the sensor should not interfere with each other.
22
Sensor Positioning
Tools and Specifications
23
Tools and Specifications
Lower the sub plate.
Board Holder Unit
Item Remark
Machinery Part Replacement
EJM8A-E-SMA050201-A01-00
Page 5-2-1-7
See "Leveling the Support Plate."
Item Remark
Machinery Part Replacement Board Holder Unit
25
Connect the cylinder air tubes.
Tools and Specifications
26
Supply power and air.
Check that the table is lowered.
Tools and Specifications
27
Level the support plate.
Tools and Specifications
Section 4-1-6
28
Put back the ceiling.
Tools and Specifications
Allen key 3 mm
Screw M4 4 pcs.
1
2
EJM8A-E-SMA050201-A01-00
Page 5-2-1-8
Put back the chute onto the rear
30
Tools and Specifications
side of the selected stage.
Allen key 4 mm
Screw M5 4 pcs.
Remark
Machinery Part Replacement Board Holder Unit
Item
29
Tools and Specifications
Phillips screwdriver #2
Round cross-head screw
M6 4 pcs.
Put back the lower cover onto the rear side of the selected stage.
Chute holding
section (Left)
Chute holding
section (Right)
EJM8A-E-SMA050201-A01-00
Page 5-2-1-9