CM602all_EJM8AESM_Service Manual.pdf - 第399页
Machinery Part Replacement Board Holder Unit Remarks Item Raise the support-plate change plate by hand. Place approximately 10-cm blocks under the plate. Loosen the cylinder plate holding unit. 3-000107 Wrench 13 mm Nut …
Machinery Part Replacement Board Holder Unit
Remarks
Turn off the main power and air supply.
ｶﾊﾞｰ達
From 0.49MPa
to 0.55MPa
Remove the lower rear chute.
ｶﾊﾞｰ達
Allen key 4 mm
Screw M5x12mm 4 pcs.
Thick washer 4 pcs.
Remove the lower rear cover.
ｶﾊﾞｰ達
Phillips screwdriver #2
Round cross-head screw
6 mm 4 pcs.
Remove the two cylinder tubes.
3-000118,000119
Item
1
3
2
4
1
2
Chute holding
section (left)
Chute holding
section (right)
EJM8A-E-SMA050204-A01-00
Page 5-2-4-2
Machinery Part Replacement Board Holder Unit
Remarks
Item
Raise the support-plate change plate by hand.
Place approximately 10-cm blocks under
the plate.
Loosen the cylinder plate holding unit.
3-000107
Wrench 13 mm
Nut 13 mm
Remove the nut from the end of the cylinder.
3-000109
Wrench 12 mm
Nut 12 mm
Remove the cylinder holding bolts.
3-000114
Allen key 3 mm
Screw M4 2 pcs.
5
6
7
8
EJM8A-E-SMA050204-A01-00
Page 5-2-4-3
Machinery Part Replacement Board Holder Unit
Remarks
Item
Pull the cylinder down and remove it.
Lock the cylinder.
3-000114
Tighten the nut at the end of the cylinder.
3-000109
Gap from the top of the nut to the end of
the screw.
Wrench 12 mm
Calipers
Tighten the cylinder plate holding nut.
3-000107
Wrench 13 mm
11
12
10
9
㎜0.5
EJM8A-E-SMA050204-A01-00
Page 5-2-4-4