CM602all_EJM8AESM_Service Manual.pdf - 第808页

• Tools • Jigs • This section describes the procedures for teaching after component-thickness-sensor reaplacement. (12-nozzle head) Option Part and Accessory Replacement Component-Thickness-Measuring Unit 6-4-3 Machine P…

100%1 / 1093
Remark
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
Item
Check the amplifier level.
Block the light of the light-emitting sensor
with the ND filter and check the amplifier
level is 600 or more. If it is less than 600,
re-adjust the sensor light-axis.
ND filter
N510013050AA
* Use the nozzle changer when fitting
the nozzles.
When the nozzle changer is not
mounted, fit the nozzles straight and
vertically, checking the nozzle
arrangement for the correct nozzles
* See Operation manual
5-5-2
A
d
j
ustment
Procedures for machine parameter
teaching
Z-axis origin offset Service manual 6-4-3
Fit the nozzles on the head using the nozzle changer.
70
71
69
ND filter
Amplifier level
EJM8A-E-SMA060402-A01-01
Page　6-4-2-20
• Tools
• Jigs
• This section describes the procedures for teaching after component-thickness-sensor reaplacement.
(12-nozzle head)
Option Part and Accessory Replacement
Component-Thickness-Measuring Unit
6-4-3 Machine Parameter Teaching Procedures (Z-axis origin offset)
* Before teaching, check no polarizing plates are attached to the head camera.
(5-11-6 Determining the Mounting Height and Positioning the Board, 5-11-7 XY Plane
Calibration, 5-11-8 Pickup Position and 5-11-10 Nozzle Exchange Position)
Notice
Before carrying out machine parameter teaching (Z-axis origin offset), save the current
machine parameters into a floppy disk. (Programming manual)
Dange
r
Warning
Caution
EJM8A-E-SMA060403-A01-00
Page　6-4-3-1
Remark
Select [Machine parameter] from the main menu.
• The machine-parameter menu screen
is displayed.
Press [Mach prmtr teach].
The "Machine parameter teaching"
screen is displayed.
2
3
(A) When Nozzles 130S are used for all the nozzle positions with the component-thickness sensor (Head-
mounted type) used (Batch teaching):
Item
1
Press [UNLOCK] and [START] on the operation panel.
Option Part and Accessory Replacement
* A component-thickness sensor (head-mounted type) is an option for the high-speed head (12-nozzle type).
The following procedures are applied to the high-speed head (12-nozzle type) only.
Component-Thickness-Measuring Unit
2
1
3
33
EJM8A-E-SMA060403-A01-00
Page　6-4-3-2