CM602all_EJM8AESM_Service Manual.pdf - 第1040页

the bolt shown with the arrow below. Phillips screwdriver #2 Screw M4 11 pcs. Carry out pickup position teaching. Position the magazine stopper. See the followings: Section 7-2-2 Direct Tray Pickup Position Teaching Sect…

100%1 / 1093
Move the extension-axis towards you 382.5 mm.
Tray Direct Tray
Remark
How to position the jig. (right picture)
Jig: FM-1924
turned by hand. Remove the jig.
Torque wrench 9.8N•m
Allen key 4 mm
Screw M5 4 pcs.
Allen key 2.5 mm
Screw M3 2 pcs.
After tightening, the bearing should be
13
Position the bearing with the jig.
14
Tighten the power locks at the motor section
with a torque wrench. TIghtening torque:
9.8N•m
16
Item
15
The dowel pin of the jig should be inside the LM, and
the hollow of the rear of the jig should on the LM.
Position the dog slit at the extension
position. Inch the axis with a pitch of 0.1
mm.
436.5
A=382.5mm
Origin position
E
C
D
(392.5)
6
F
Magazine
(2)
(51)
B=9
Supply
section
Magazine side
(0.5 mm)
Lift side
(1.0 mm)
Optical-axis sensor
Extension position PH sensor
PH632( 32)
　Dog
Light through: ON
Light blocked: OFF
Light blocked at mechanical stopper on negative direction.
Supply section
EJM8A-E-SMA070208-A01-00
Page 7-2-8-5
the bolt shown with the arrow below.
Phillips screwdriver #2
Screw M4 11 pcs.
Carry out pickup position teaching.
Position the magazine stopper.
See the followings:
Section 7-2-2 Direct Tray
Pickup Position Teaching
Section 7-2-3 Magazine
Shutter Stopper Position
Adjustment
Tray
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
19
Direct Tray
Item Remark
Rear
Right
17
18
Close the cover.
Left. Stay at the front side when tightening
Put the cover back on.
EJM8A-E-SMA070208-A01-00
Page 7-2-8-6
Tray
Min.
kgs.
30
Direct Tray
• This section describes the procedures for replacing the extension-axis driver.
Total Part Weight
280
7-2-9 Extension-axis Driver Replacement
None
Phillips screwdriver #2
Precision screwdriver
Nippers
Allen key M4
Teaching
Assembly/AdjustmentRemoval/Disassembly
30
Min. Min. Min.
20
Tool
Jig
Caution
Danger
Warning
EJM8A-E-SMA070209-A01-00
Page 7-2-9-1