CM602all_EJM8AESM_Service Manual.pdf - 第390页
Kgs . Total Time Weight o f Part 15 min . Removal Disassembl y A ssembly A d j ustment Teaching min. 7 min. 8 min. ・ Tools Machinery Part Replacement Board Holder Unit This section describes the procedures for replacing …
Put back the chute onto the rear
30
Tools and Specifications
side of the selected stage.
Allen key 4 mm
Screw M5 4 pcs.
Remark
Machinery Part Replacement Board Holder Unit
Item
29
Tools and Specifications
Phillips screwdriver #2
Round cross-head screw
M6 4 pcs.
Put back the lower cover onto the rear side of the selected stage.
Chute holding
section (Left)
Chute holding
section (Right)
EJM8A-E-SMA050201-A01-00
Page 5-2-1-9
Kgs
.
Total Time
Weight o
f
Part
15
min
.
Removal
Disassembl
y
A
ssembly
A
d
j
ustment
Teaching
min.7 min. 8 min.
・Tools
Machinery Part Replacement Board Holder Unit
This section describes the procedures for replacing the upper and the lower limit sensors for the support plate.
5-2-2
Support Plate Upper and Lower Limit Sensor Replacement
Phillips screwdriver #2
Allen key 2.5 mm
None
・Jig
Dange
r
Warning
Caution
EJM8A-E-SMA050202-A01-00
Page 5-2-2-1
Phillips screwdriver #2
Screw M4 2 pcs.
Tools and Specifications
Remark
Remove the sensors.
2
1
Item
Remove the feeder cover.
Switch off the main power.
Machinery Part Replacement Board Holder Unit
Tools and Specifications
Tools and Specifications
Tools and Specifications
3
4
Remove the sensor connector.
Allen key 2.5 mm
Screw M3 2 pcs.
Lower limit
sensor
Upper limit
sensor
Do not loosen.
EJM8A-E-SMA050202-A01-00
Page 5-2-2-2