CM602all_EJM8AESM_Service Manual.pdf - 第843页
Remarks PCB-Warp-Sensor Unit Item Option Part and Accessory Replacement Secure the amplifier cable. - (2) Connect the amplifier connector. * Amplifier connector CN13 Put the head upper cover back on. Phillips screwdriver…
Remarks
PCB-Warp-Sensor Unit
Item
Option Part and Accessory Replacement
Remove the amplifier.
Wrench M4
Hexagon bolt M4
Install the new amplifier.
Wrench M4
Hexagon bolt M4
Connect the connector.
Secure the amplifier cable. - (1)
* Put the cable behind the amplifier, and
to the left. Secure the cable at the
specified position with a cable tie.
10
11
9
12
Loosen the two M4x12L bolts.
Remove the amplifier.
Tighten the two M4x12L bolts.
Install the new amplifier.
<Caution>
Create a 2-mm gap between
the amplifier and the plate
when installing the amplifier.
Connect the sensor connector (To
amplifier), aligning the pin position.
Turn the cap screw, whcih is placed at
the end of the cable, to the right. Fix it
in place.
Cable-tie position
EJM8A-E-SMA060501-A01-01
Page 6-5-1-4
Remarks
PCB-Warp-Sensor Unit
Item
Option Part and Accessory Replacement
Secure the amplifier cable. - (2)
Connect the amplifier connector.
* Amplifier connector CN13
Put the head upper cover back on.
Phillips screwdriver #2
Truss M4 screw 4 pcs.
Put the feeder cover back on.
Allen key 3 mm
Screw M4 4 pcs.
16
13
14
15
Connect the amplifier connector.
Cable-tie position
EJM8A-E-SMA060501-A01-01
Page 6-5-1-5
Remarks
PCB-Warp-Sensor Unit
Item
Option Part and Accessory Replacement
Turn on the power and air supply.
PCB-warp-sensor adjustment
Teaching
Adjusting the amplifier 0 reference
position (0-volt adjustment)
Adjusting the slant (span) of amplifier
(+2-volt adjustment)
XY offset teaching
See Section 6-5-5
17
18
1
2
EJM8A-E-SMA060501-A01-01
Page 6-5-1-6