CM602all_EJM8AESM_Service Manual.pdf - 第915页
Lift will Fall! When the coupling is loosened, the lift will fall down. To avoid this, hold the ball screw with a wrench. After tightening the coupling, remove the wrench. Remraks Item Specifications: ±1.0mm or less When…
Mount the palette jigs on the lift table and the replenishment table.
Jig: FM0558
Palette jig
Tray
Item Remraks
13
Block (Not designated)
Return the lift-axis to the origin.
16
Shuttle Tray
Remove the block which holds the lift-axis.
14
Raise the lift-axis by 422 st.
15
422
EJM8A-E-SMA070106-A01-00
Page 7-1-6-5
Lift will Fall!
When the coupling is loosened, the lift
will fall down. To avoid this, hold the
ball screw with a wrench.
After tightening the coupling,
remove the wrench.
RemraksItem
Specifications:
±1.0mm or less
When the difference in
height between the lift and
the replenishment tables is
+/- 1.0 mm or less,
proceed to Step 22 and
enter the parameter.
Measure the height of the jigs.
Reference: Jig on the replenishment table.
remove the coupling.
Allen key 4 mm
Wrench 14 mm
Screw M5 6 pcs.
Holding the ball screw with a wrench,
Measure the height of the jig.
Specifications:
±1.0 mm or less
Adjust the height of the lift table, turning the wrench.
Specifications:
Tightening torque:
8.0N・m
A=2mm±1mm
Allen key 5mm
Ruler 150mm
M6 6 pcs.
Tighten the lift-axis motor coupling.
20
19
18
17
Tray Shuttle Tray
Replenishment
table
Lift table
If the cover cannot be
removed
,
hold here.
Wrench
A
To
lower
To
raise
EJM8A-E-SMA070106-A01-00
Page 7-1-6-6
Item Remraks
21
Specifications:
±1.0 mm or less
After tightening the coupling, confirm the height.
Enter the measured value into [TL] manually.
22
Tray Shuttle Tray
+
-
EJM8A-E-SMA070106-A01-00
Page 7-1-6-7