CM602all_EJM8AESM_Service Manual.pdf - 第691页
Machinery Part Replacement This section describes the procedures for teaching the pickup position. Tools None Jig FM-1043 Nozzle Height Teaching Jig Nozzle 130S Install the feeder change cart. 12-Nozzle Head Teaching 5-1…
Machinery Part Replacement
Remarks
12-Nozzle Head Teaching
Item
Change stages.
Select Stage B.
Carry out Steps 2 to 8 in the same way
as Stage A.
Check the data after teaching.
The offsets are entered automatically into the screen below:
Offset range:
X: -0.5 mm to +0.5 mm
Y: -0.5 mm to +0.5 mm
11
9
10
EJM8A-E-SMA051107-A01-00
Page 5-11-7-4
Machinery Part Replacement
This section describes the procedures for teaching the pickup position.
Tools
None
Jig
FM-1043
Nozzle Height Teaching
Jig
Nozzle 130S
Install the feeder change cart.
12-Nozzle Head Teaching
5-11-8 Pickup Position
Caution
Dange
r
Warning
EJM8A-E-SMA051108-A01-00
Page 5-11-8-1
Machinery Part Replacement
Remarks
Press [Pickup position].
Select the stage to teach.
Check that:
"XY" and "Z" are selected
(highlighted).
Check that "Check Posi L
table" is selected.
If "Check Posi R table" is
selected, press that key to
change "R" to "L."
Select the left table.
Press [Jig setting].
• Put the 130S nozzle on the number 5
nozzle position of the head for the stage to
teach.
• Put the pickup-position-adjusting jig on the
number 2 position of the feeder change cart.
4
1
Item
2
12-Nozzle Head Teaching
3
Pickup-position-adjusting jig
EJM8A-E-SMA051108-A01-00
Page 5-11-8-2