CM602all_EJM8AESM_Service Manual.pdf - 第64页
Setting Machine Setting 2 Remarks Remove the feeder cover. Remove the NG discharge box. Phillips screwdriver #2 Screw M4 2 pcs. 1 Phillips screwdriver #2 Screw M4 2 pcs. Tool/Spec./Installation Place the levels as shown …
Before levelin
g
the machine, be sure to check the levelness of the levels.
Removal/Disassembly Assembly/Adjustment
Teaching
Total time
3500 kg30 min30 min. 60 minmin
This section describes the procedures for leveling the machine.
Allen key
Wrench 46 mm
Level 3 pcs. or more
2-1-2 Leveling the Machine
Setting Machine Setting
Part weight
・Tools
・Jig
Dange
r
Warning
Caution
EJM8A-E-SMA020102-A01-00
Page 2-1-2-1
Setting Machine Setting
2
Remarks
Remove the feeder cover.
Remove the NG discharge box.
Phillips screwdriver #2
Screw M4 2 pcs.
1
Phillips screwdriver #2
Screw M4 2 pcs.
Tool/Spec./Installation
Place the levels as shown below and check the levelness.
Item
3
60
9
245
1
Operator's side
60
43
9
245
9
245
77
9
245
36
36
77
2
3
4
5
60
43
６
EJM8A-E-SMA020102-A01-00
Page 2-1-2-2
Clean the mounting side and the bottom
of the level. Position the level.
Check the reading of the level.
Rotate the level 180 degrees while
leaving it in the current position.
The example at left: NG
Check the reading again.
The readings are different
between Steps 4-2 and 4-3.
[Judgment G/NG]
The readings are the same in Steps 1 and 2: Good
The readings are different: NG
Specifications: The reading should be
the same after the level is rotated 180
degrees. (0 division)
Level the level with the adjustment
screw.
Rotate the level 180 degrees.
Adjust the level.
When the reading does not
change after the level is
rotated 180 degrees: Good
Setting Machine Setting
4-3
Tool/Spec./Installation
Tool/Spec./Installation
Item
Check the condition of the level.
4-2
Tool/Spec./Installation
Remarks
4-4
4-1
Place the level in the X direction
Place the level in the Y direction
as shown below: as shown below:
EJM8A-E-SMA020102-A01-00
Page 2-1-2-3