CM602all_EJM8AESM_Service Manual.pdf - 第502页
Machinery Part Replacement Remarks Z Unit (3-nozzle type) Item Check that the connectors and the tubes are connected to the new head. Install the head. Tighten the head-holding screws. Allen key 3 mm Screw M4 5 pcs. Conn…
Machinery Part Replacement
Remarks
Z Unit (3-nozzle type)
Item
Remove the earth cable and the connector.
5
Phillips screwdriver #2
Truss screw M4 1 pc.
Cut off the cable tie.
取り直し
Disconnect the camera and LED lamp
connectors.
Remove the head-holding screws. Hold the head to avoid letting it fall.
Allen key 3 mm
Screw M4 5 pcs.
6
7
8
Put the pin down.
Pull it out.
EJM8A-E-SMA050502-A01-00
Page 5-5-2-3
Machinery Part Replacement
Remarks
Z Unit (3-nozzle type)
Item
Check that the connectors and the tubes are connected to the new head.
Install the head. Tighten the head-holding screws.
Allen key 3 mm
Screw M4 5 pcs.
Connect the LED lamp and camera connectors.
Secure the cables with cable ties.
12
9
10
11
Put down the pin.
Insert it.
EJM8A-E-SMA050502-A01-00
Page 5-5-2-4
Machinery Part Replacement
Remarks
Z Unit (3-nozzle type)
Item
Connect the air, vacuum, and electropneumatic regulator tubes.
Be sure to lock it.
Phillips screwdriver #2
Truss screw M4 1 pc.
Put the head cover back on.
Phillips screwdriver #1
Phillips screwdriver #2
Screw M3 2 pcs.
Screw M4 2 pcs.
Put the feeder cover back on. Remove the bubble wrap.
Phillips screwdriver #2
Screw M4 2 pcs.
15
16
14
Secure the connector and the earth cable.
13
EJM8A-E-SMA050502-A01-00
Page 5-5-2-5