CM602all_EJM8AESM_Service Manual.pdf - 第484页

Machinery Part Replacement Remarks Item Light Transfer-Head Assembly (3-nozzle type) Switch on the power and air suppl y. Teaching Chip Recognition Camera --- Theta Axis Origin Offset Determining the Mounting Height and …

100%1 / 1093
Machinery Part Replacement
Remarks
Item
Light Transfer-Head Assembly (3-nozzle type)
Put the cable-holding bracket back on.
13
Specifications: 85 mm to
90 mm
Phillips screwdriver #2
Screw M4 2 pcs.
Connect the connector to the replaced unit.
2-000163
Put the head cover back on.
2-000157、000158
Phillips screwdriver #1
Phillips screwdriver #2
Screw M3 2 pcs.
Screw M4 2 pcs.
Put the feeder cover back on. Remove the bubble wrap from the table.
Phillips screwdriver #2
Screw M4 2 pcs.
15
14
16
85 mm to 90 mm
EJM8A-E-SMA050402-A01-00
Page 5-4-2-5
Machinery Part Replacement
Remarks
Item
Light Transfer-Head Assembly (3-nozzle type)
Switch on the power and air suppl
y.
Teaching
Chip Recognition Camera --- Theta Axis
Origin Offset
Determining the Mounting Height and
Positioning the Board
Pickup Position
Nozzle Exchange Position
Load Head
Lead Checker
Section 4-3-4
Section 4-3-5
Section 4-3-8
Section 4-3-9
Section 4-3-10
Section 4-3-11
18
17
1
2
EJM8A-E-SMA050402-A01-00
Page 5-4-2-6
Light Transfer-Head Assembly (3-nozzle type)
60
Min.
Machinery Part Replacement
• Tools
• Jigs
This section describes the procedures for replacing the nozzle shaft.
5-4-3 Nozzle Shaft Replacement
Removal/Disassembly Assembly/Adjustment
Allen key 1.5 mm
Allen key 2 mm
Allen key 2.5 mm
Allen key 3 mm
Snap ring pliers
Wrench 10 mm
Wrench 17 mm
Locktite 221
Theta-motor-center-
alignment jig
Piston tightening jig
Part Weight
Kg
130
Min.
Teaching Total Time
70
Min. Min.
Caution
Danger
Warning
EJM8A-E-SMA050403-A01-00
Page 5-4-3-1