CM602all_EJM8AESM_Service Manual.pdf - 第568页

Machinery Part Replacement Remarks Feeder Gang Exchange Cart Holding Section Item Press [Gang change start]. The following steps are the removal procedures. Open the top cover. Open the feeder cover. The machine judges w…

100%1 / 1093
Machinery Part Replacement
Remarks
Feeder Gang Exchange Cart Holding Section
Item
The unit table is lowered and the casters
are raised.
Close the feeder cover.
The machine judges whether the feeder
cover is open or closed as follows:
The tape float sensor is blocked;
the cover is open.
The sensor is NOT blocked;
the cover is closed.
Close the top cover.
Lower the handles. Cart installation is complete.
9
10
11
12
EJM8A-E-SMA050801-A01-00
Page5-8-1-4
Machinery Part Replacement
Remarks
Feeder Gang Exchange Cart Holding Section
Item
Press [Gang change start].
The following steps are the removal
procedures.
Open the top cover.
Open the feeder cover.
The machine judges whether the feeder
cover is open or closed as follows:
The tape float sensor is blocked;
the cover is open.
The sensor is NOT blocked;
the cover is closed.
Press [Feeder base up].
14
15
13
16
When the
table is
lowered:
When the
table is
raised:
Unit table
EJM8A-E-SMA050801-A01-00
Page5-8-1-5
Machinery Part Replacement
Remarks
Feeder Gang Exchange Cart Holding Section
Item
The casters are lowered and the unit table is raised.
Pull the cart out of the machine.
Disconnect the connector.
Be careful!
Once the connector has been removed,
the cart table is lowered.
Close the feeder cover.
17
18
19
20
EJM8A-E-SMA050801-A01-00
Page5-8-1-6