CM602all_EJM8AESM_Service Manual.pdf - 第221页
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles) This section describes the procedures for carrying out the XY plane calibration. ・ Tools None ・ Jig FM-1045 XY plane calibration jig 510 mm x 460 mm Remove …
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press the "Unlock" key and [Jig adjust] simultaneously.
Check that "Left" is selected for the jig
position. Press the jig against the board
clamp holding guide and the board
stopper.
Be careful of the
orientation of the jig.
(The hole of the jig should
face the stopper and the
fixed guide.)
Press the "Unlock" key and [Mnt Height tch] simultaneously.
While the nozzle ascends and descends
above the jig, the vacuum pressure is
measured and the offset is set
automatically.
Only the mounting height is taught on the
rear side.
Check the data after teaching.
19
The offsets are entered into the screens below:
Offset range:
Board stopper offset:
X: -2.0 mm to +2.0 mm
Y: -2.0 mm to +2.0 mm
Mounting position offset:
X: -1.0 mm to +1.0 mm
Y: -1.0 mm to +1.0 mm
Z: -1.0 mm to +1.0 mm
18
20
17
Stopper
Fixed guide
There should
be no gap.
EJM8A-E-SMA040205-A01-00
Page 4-2-5-6
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
This section describes the procedures for carrying out the XY plane calibration.
・Tools
None
・Jig
FM-1045
XY plane calibration jig
510 mm x 460 mm
Remove dirt from the
recognition side of the jig
with soft cloth.
4-2-6 XY Plane Calibration
Remove the support pins beforehand.
Handle the jig with care since it is made of glass.
This calibration should be carried out on the operator's side;
it cannot be performed at the rear.
Assembly
Adjustment
min.
Teaching
20min.
Total Time Weight of
Part
Removal
Disassembly
min.
20min. kgs
Caution
Dange
r
Warning
EJM8A-E-SMA040206-A01-00
Page 4-2-6-1
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Press [XY plane cal].
Conveyor width is
adjusted automatically.
(Y=460㎜)
Press [Jig setting].
The AF head moves away.
Place the jig on the conveyor.
Place the jig by hand, pressing the
reference-mark corner of the jig against
the fixed conveyor and the board
stopper.
Press [Jig adjust].
The jig is clamped in the Y direction.
(Option)
Check that the jig is
locked once it is clamped
in the Y direction.
3
4
1
Item
2
EJM8A-E-SMA040206-A01-00
Page 4-2-6-2