CM602all_EJM8AESM_Service Manual.pdf - 第242页
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles) Remarks Item Press the [Return] key. To save the machine parameter, press the [Return] key. Press [Unlock] and [Run] simultaneously. All axes of the selecte…
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press [Teach Posi L table].
Change "Teach Posi L table" to "Teach
Posi R table."
If "Teach Posi L table" is
selected, press that key to
change "L" to "R."
Press [Unlock] and [Jig setting] simultaneously.
Place the jig at Position
27 of the feeder table of
the selected stage.
Press [Unlock] and [Pick pos teach] simultaneously.
The head moves over to the jig.
The head camera recognizes the hole on
the jig so that X and Y of the pickup
position are recognized and corrected.
Nozzle 3 descends to the jig so that Z of
the pickup position is determined.
Press [Unlock] and [Jig remove] simultaneously.
The head moves to the nozzle set
position (over the NG box).
Remove the jig and the
nozzle.
5
6
7
8
EJM8A-E-SMA040208-A01-00
Page 4-2-8-3
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
Remarks
Item
Press the [Return] key.
To save the machine
parameter, press the
[Return] key.
Press [Unlock] and [Run] simultaneously.
All axes of the selected stage return to
the origin.
The offsets are entered automatically into the screen below:
Offset range:
X: +/- 1.0 mm
Y: +/- 1.0 mm
Z: +/- 1.0 mm
9
10
11
EJM8A-E-SMA040208-A01-00
Page 4-2-8-4
Maintenance Adjustment Light Transfer-Head Assembly (8 nozzles)
This section describes the procedures for determining the nozzle exchange position.
Tools
None
Jig
Non registered
Nozzle Changer Position
Recognition Jig
Nozzle 120 or 130
4-2-9 Nozzle Exchange Position
Clean the upper surface of the nozzle changer beforehand.
Assembly
A
d
j
ustment
min.
Teaching
5 min.
Total Time Weight of
Part
Removal
Disassembl
y
min.
5 min.
kgs
Caution
Dange
r
Warning
EJM8A-E-SMA040209-A01-00
Page4-2-9-1