CM602all_EJM8AESM_Service Manual.pdf - 第913页
Adjust the motor position, so that the jig rotates smoothly. Item Remraks Allen key 5 mm Screw M5 4 pcs. Fix the new motor in place tentatively. 9 remove the jig, and completely tighten the motor screws. Allen key 5 mm S…
Lift will Fall!
When the coupling is loosened, the lift
will fall down. To avoid this, hold the
ball screw with a wrench.
Block (Not designated)
Remove the motor connectors.
Allen key 5 mm
Screw M5 4 pcs.
Remove the motor holding screws.
5
Item
Allen key 4 mm
Wrench 14 mm
Screw M5 6 pcs.
After removing the coupling, hold the lift-axis with a block,
remove the coupling.
6
7
8
Tray Shuttle Tray
Remraks
Holding the ball screw with a wrench,
and remove the wrench.
If the cover cannot be
removed
,
hold here.
EJM8A-E-SMA070106-A01-00
Page 7-1-6-3
Adjust the motor position, so that
the jig rotates smoothly.
Item Remraks
Allen key 5 mm
Screw M5 4 pcs.
Fix the new motor in place tentatively.
9
remove the jig, and completely tighten the motor screws.
Allen key 5 mm
Screw M5 4 pcs.
Fit the alignment jig.
Alignment jig
Once the adjustment is complete,
Tighten the lift-axis motor coupling.
Specifications:
Tightening torque:
8.0N・m
A=2mm±1mm
Allen key 5 mm
Ruler 150 mm
Screw M6 6 pcs.
12
10
11
Tray Shuttle Tray
A
EJM8A-E-SMA070106-A01-00
Page 7-1-6-4
Mount the palette jigs on the lift table and the replenishment table.
Jig: FM0558
Palette jig
Tray
Item Remraks
13
Block (Not designated)
Return the lift-axis to the origin.
16
Shuttle Tray
Remove the block which holds the lift-axis.
14
Raise the lift-axis by 422 st.
15
422
EJM8A-E-SMA070106-A01-00
Page 7-1-6-5