CM602all_EJM8AESM_Service Manual.pdf - 第944页

After loosening the motor locks, hit them lightly to remove them. Item Remarks Allen key 2.5 mm M3 8 pcs. 9 Put the palette table back on. Loosen the power locks at the motor section. 10 11 12 Allen key 4 mm Screw M5 4 p…

100%1 / 1093
Remove the belt clamp unit. Replace the belt.
Loosen the tensions at the motor section.
Allen key 3 mm
Screw M4 2 pcs.
After replacing the belt, tighten the belt clamp unit.
Position the belt. Tighten the tensions at the motor section.
Allen key 5 mm
Screw M6 2 pcs.
Item
Allen key 3 mm
Screw M4 2 pcs.
5
Remarks
Shuttle Tray
6
7
8
Tray
EJM8A-E-SMA070111-A01-00
Page　7-1-11-3
After loosening the motor locks,
hit them lightly to remove them.
Item Remarks
Allen key 2.5 mm
M3 8 pcs.
9
Put the palette table back on.
Loosen the power locks at the motor section.
10
11
12
Allen key 4 mm
Screw M5 4 pcs.
Switch on the power.
Tray Shuttle Tray
Return the extension-axis to the origin.
EJM8A-E-SMA070111-A01-00
Page　7-1-11-4
Item Remarks
13
Move the extension-axis forward by 436.5 st.
Allen key 2.5 mm
Screw M3 2 pcs.
Allen key 4 mm
Screw M5 4 pcs.
Position the bearing with the jig.
Jig: FM-0982
16
Position the slit of the dog slit in the extension position.
Inch the extension-axis (One inching: 0.1mm)
section.
14
15
Tighten the power locks of the motor
Tray Shuttle Tray
436.5
A=436.5 st
Origin
E
CD
(454.5)
8
F
B=11.0
Shutter
(2)
(73)
Magazine side
(0.5㎜)
Lift side
(1.0㎜)
Light beam sensor
Extension position
PH sensor
　Dog
EJM8A-E-SMA070111-A01-00
Page　7-1-11-5