CM602all_EJM8AESM_Service Manual.pdf - 第782页

Remark Item Component-Thickness-Measuring Unit Option Part and Accessory Replacement Out p ut-2 threshold settin g Press the "Manual" button until the value becomes 2000. 32 30 31 33 Check " hsp "and …

100%1 / 1093
Remark
Item
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
A
mplifier setting
Settin
g
of nozzle front line
(
1 to 6
)
CN40
27
28
29
Hold down the Mode
button for a few
seconds.
When "L-on" is displayed,
press the Manual button to
change the display to "d-on."
* Press either side of the button.
Check "d-on" and press
the Mode button.
* Do not hold it down for
a long time.
When "FinE" is displayed,
press the Manual button
to change the display to
"hsp."
To the next page
Mode button
A
dd-in
p
rotection cover
C
hannel switch
(
dis
p
la
y
settin
g)
Manual button
Dust cover
A
dd-in connector
Di
g
ital monitor
Set button
Hold lock
bar
Out
p
ut indicator
(
Control out
p
ut 2
)
Out
p
ut indicator
(
Control out
p
ut 1
)
EJM8A-E-SMA060401-A01-01
Page　6-4-1-9
Remark
Item
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
Out
p
ut-2 threshold settin
g
Press the "Manual" button until the value
becomes 2000.
32
30
31
33
Check "hsp"and press
the Mode button.
* Do not hold it down for
a long time.
Check "End"and press
the Mode button.
* Do not hold it down for
a long time.
"End" is displayed and the
original display is returned.
Hold down the
"←" of the
Manual
button
until
1250
Check "1250" and
change the channel
switch from 1 to 2.
End of
amplifier setting
From the previous page
Threshold
EJM8A-E-SMA060401-A01-01
Page　6-4-1-10
Remark
Item
Component-Thickness-Measuring Unit
Option Part and Accessory Replacement
Chan
g
e the am
p
lifier out
p
ut t
yp
e to "1."
Settin
g
of nozzle rear line
(
7 to 12
)
CN39
36
35
34
Check the condition of the amplifier with the sensor light blocked.
Repeat the above-mentioned procedures
to set the other amplifier.
After finishing setting the
amplifier, blocking the light
of the front (1 to 6) and the
rear sensors (7 to 12) one by
one, check the condition of the
amplifier for the front and rear
separately.
Rear sensor (7 to 12)
Front sensor (1 to 6)
With the sensor light
blocked, this light
should be turned ON.
With the sensor light
blocked, the value should
be reduced.
With the sensor light
blocked, this light
should be turned ON.
With the sensor light
blocked, the value should
be reduced.
Switch the channel to "1."
EJM8A-E-SMA060401-A01-01
Page　6-4-1-11