CM602all_EJM8AESM_Service Manual.pdf - 第592页
Machinery Part Replacement ・ Tools Phillips screwdriver #2 Allen key 3 mm Allen key 5 mm Pipe Nipper Dial gauge Magnetic stand Plate ・ Jig FM-0988 Cutting unit positioning jig Cutting Unit 5-9-4 Cutter Unit Replacement T…
Machinery Part Replacement
Remarks
Cutting Unit
Item
Control the pressurization.
Size of shim to be
inserted
=(b+c)-(a+0.1)
Pressurization:
0.09 mm to 0.11mm
Target pressure: 0.1 mm
Fit the fulcrum pin.
Wrench 24 mm
Allen key 8 mm
24-mm bolt pin 1 pc.
Screw M10 1 pc.
Wrench 7 mm
Spacer 1 pc.
Put the cutter unit back on.
Refer to "Cutter Unit Replacement" Section 5-9-4
Fit the top cover spacer close to the fulcrum pin.
7
8
5
6
b
c
a
Insert a shim
C: The highest point of the bearing when
you press the bearing, rotating it.
a
b
EJM8A-E-SMA050903-A01-00
Page 5-9-3-3
Machinery Part Replacement
・Tools
Phillips screwdriver #2
Allen key 3 mm
Allen key 5 mm
Pipe
Nipper
Dial gauge
Magnetic stand
Plate
・Jig
FM-0988
Cutting unit positioning jig
Cutting Unit
5-9-4 Cutter Unit Replacement
This section describes the procedures for replacing the cutter unit.
・The cutter unit is heavy; remove with care.
・Don't touch the cutter blades. Otherwise you may cut your hand.
Assembly
A
d
j
ustment
25min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembl
y
20min.
45min.
40kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050904-A01-00
Page 5-9-4-1
Machinery Part Replacement
Remarks
Switch off the main power and air supply.
Remove the feeder cover and the chute.
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4x10mm 3 pcs.
Thick washer 3 pcs.
Remove the cylinder tubes to release air.
Since pressure is applied, pushing the
hose holding ring with a wrench or an
equivalent tool, remove the hose.
Magic marker
Air tube φ8 4 pcs.
Remove the upper cutter cover.
Allen key 3 mm
Screw M4x8mm 5 pcs.
Cutting Unit
Item
2
3
1
4
1
2
EJM8A-E-SMA050904-A01-00
Page 5-9-4-2