CM602all_EJM8AESM_Service Manual.pdf - 第155页
Maintenance Adjustment Main Body Beam Remarks Set the support plates. Take care with orientation of the plates. Widen the conveyor to maximum. Type L: 460.00 mm Place the support pins on the plates. Support pin: 74 mm It…
Maintenance Adjustment Main Body Beam
・Tools
Phillips screwdriver #2
Allen key 2.5 mm
Allen key 3 mm
Wrench 13 mm
Iron plate
Dial gauge
Magnetic stand
・Jig
None
Be sure to turn off the SERVO switch when working on the machine.
4-1-6 Leveling the Support Plate
This section describes the procedures for leveling the support plate.
Assembly
Adjustment
20min.
Teaching
50min.
Total Time Weight of
Part
Removal
Disassembly
20min.
90min.
kgs
Caution
Dange
r
Warning
EJM8A-E-SMA040106-A01-00
Page 4-1-6-1
Maintenance Adjustment Main Body Beam
Remarks
Set the support plates.
Take care with orientation of the plates.
Widen the conveyor to maximum.
Type L: 460.00 mm
Place the support pins on the plates.
Support pin: 74 mm
Item
2
3
1
4
Press [Support pin change] to set the support plates.
EJM8A-E-SMA040106-A01-00
Page 4-1-6-2
Maintenance Adjustment Main Body Beam
Remarks
Item
Raise the support plates. Select the desired stage.
Set [Holder] to [ON] to
raise the support plate.
Allen key 3 mm
Iron plate
Screw M4
Loosen the four nuts.
(Two nuts at the front; two at the rear)
Wrench 13 mm
Dial gauge
Magnetic stand
Place the iron plate on the head assembly.
Measure the height of the pin with the dial gauge
7
8
5
6
Adjusting
bolts
EJM8A-E-SMA040106-A01-00
Page 4-1-6-3