CM602all_EJM8AESM_Service Manual.pdf - 第397页
Machinery Part Replacement Board Holder Unit This section describes the procedures for replacing the support-plate change plate ascending cylinder. ・ Tools Phillips screwdriver #2 Allen key 3 mm Allen key 4 mm Wrench 12 …
The sensor and the dog should not
interfere with each other.
Machinery Part Replacement Board Holder Unit
Item Remark
9
Switch on the main power.
Tools and Specifications
Tools and Specifications
Tools and Specifications
Phillips screwdriver #2
Screw M4 2 pcs.
Tools and Specifications
12
Supply air.
11
Put back the feeder cover.
10
Check the sensor position.
1
2
EJM8A-E-SMA050203-A01-00
Page 5-2-3-4
Machinery Part Replacement Board Holder Unit
This section describes the procedures for replacing the support-plate change plate ascending cylinder.
・Tools
Phillips screwdriver #2
Allen key 3 mm
Allen key 4 mm
Wrench 12 mm
Wrench 13 mm
Calipers
・Jig
None
5-2-4 Support-Plate Change Plate Ascending Cylinder Replacement
Remove the support pins and support plate before replacement.
Assembly
Adjustment
22min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembly
23min.
45min. kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050204-A01-00
Page 5-2-4-1
Machinery Part Replacement Board Holder Unit
Remarks
Turn off the main power and air supply.
ｶﾊﾞｰ達
From 0.49MPa
to 0.55MPa
Remove the lower rear chute.
ｶﾊﾞｰ達
Allen key 4 mm
Screw M5x12mm 4 pcs.
Thick washer 4 pcs.
Remove the lower rear cover.
ｶﾊﾞｰ達
Phillips screwdriver #2
Round cross-head screw
6 mm 4 pcs.
Remove the two cylinder tubes.
3-000118,000119
Item
1
3
2
4
1
2
Chute holding
section (left)
Chute holding
section (right)
EJM8A-E-SMA050204-A01-00
Page 5-2-4-2