CM602all_EJM8AESM_Service Manual.pdf - 第78页
■ Check that the machine cover is not damaged when transferred. ■ If the linear-rails, the ball screw, and other parts are rusted, remove rust. ■ If there are cracks on the cover, paint it. ■ Wipe out rust-preventive and…
Check vacuum with your finger.
When the nozzle is blown, change the
primary-side electric source cables and
check again.
Check vacuum with your finger.
When the nozzle is blown, change the
primary-side electric source cables and
check again.
Machine Installation
Check vacuum
.
Select "Machine adjust" ⇒ "Output check."
Remark
Check the direction of vacuum pump.
Turn off the servo. Check vacuum of the nozzle.
Item
31
32
29
Installation
30
Check the direction of the vacuum pump.
"Output check" window
Check the direction of the vacuum pum
p
Turn on the vacuum pump
(1) Unlock (2) Vacuum pump (3) Vacuum
(1)
(2)
(2)
(1)
(3)
EJM8A-E-SMA020103-A01-00 Page 2-1-3-9
■ Check that the machine cover is not
damaged when transferred.
■ If the linear-rails, the ball screw, and
other parts are rusted, remove rust.
■If there are cracks on the cover,
paint it.
■Wipe out rust-preventive and grease
which were applied before delivery.
Remove oil grease
.
Remove oil grease
.
X-side level gauge mounting sectio
n
Y-side level gauge mounting sectio
n
36
Remove oil grease
.
When the machine is operated: 0.50MPa to 0.55MPa
Check reading of the air pressure switc
h
[Targeted value]
Normal machine operation:
0.50MPa to 0.55 Mpa
* Air pressure changes,
depending on environment.
Adjust it, checking
operation condition.
Check air pressure
33
Installation
Item
Remove oil grease
.
35
34
High-speed nozzle change Multi-purpose nozzle change
Machine Installation
Remark
Rust is made: Check there is no damag
e
Remove oil grease from the clam
p
on appearance
.
section of each stage
.
EJM8A-E-SMA020103-A01-00 Page 2-1-3-10
. Check that a warning message and
an error message appear when either
of the emergency stop switch is
pressed.
. This warning window appears when the
machine is attempted to be operated
with the emergency stop switch pressed.
. An error occurs when the emergency
stop switch is pressed during machine
operation (Power ON).
. To reset the switch, pull it.
. Turn off the servo switch.
Operate the machine. (auto run)
Check that the error message
appears.
40
one for each side, front and rear.
39
"Emergency Stop Error" windo
w
"Emergency Stop Error" windo
w
Check the servo switches.
Installation Machine Installation
Item Remark
37
Check the emergency stop switches:
one for each side, front and rear.
38
"Emergency Stop Warning" window
EJM8A-E-SMA020103-A01-00 Page 2-1-3-11