CM602all_EJM8AESM_Service Manual.pdf - 第1041页
Tray Min. kgs. 30 Direct Tray • This section describes the procedures for replacing the extension-axis driver. Total Part Weight 2 80 7-2-9 Extension-axis Driver Replacement None Phillips screwdriver #2 Precision screwdr…
the bolt shown with the arrow below.
Phillips screwdriver #2
Screw M4 11 pcs.
Carry out pickup position teaching.
Position the magazine stopper.
See the followings:
Section 7-2-2 Direct Tray
Pickup Position Teaching
Section 7-2-3 Magazine
Shutter Stopper Position
Adjustment
Tray
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
19
Direct Tray
Item Remark
Rear
Right
17
18
Close the cover.
Left. Stay at the front side when tightening
Put the cover back on.
EJM8A-E-SMA070208-A01-00
Page 7-2-8-6
Tray
Min.
kgs.
30
Direct Tray
• This section describes the procedures for replacing the extension-axis driver.
Total Part Weight
280
7-2-9 Extension-axis Driver Replacement
None
Phillips screwdriver #2
Precision screwdriver
Nippers
Allen key M4
Teaching
Assembly/AdjustmentRemoval/Disassembly
30
Min. Min. Min.
20
Tool
Jig
Caution
Danger
Warning
EJM8A-E-SMA070209-A01-00
Page 7-2-9-1
3
4
Remove the control-box front cover.
Remark
Turn off the power.
Remove the control-box front cover.
Item
Direct TrayTray
Remove the lift-axis driver.
• Remove all the connectors from the
front of the control box and from the
board.
• Remove the cable tie from the front of
the control box.
• Remove the box-holding screws.
2
1
EJM8A-E-SMA070209-A01-00
Page 7-2-9-2