CP643 系统参考.pdf - 第197页
SET 500-0-0 Command Pass : [SET] Press to make other settings. Revision History ST A TUS 510-0-0 Command Pass : [SET] - [STATUS] Press to change the machine status. Revision History RECOVER Y 51 1-0-0 Command Pass : [SET…
-PAGE 455-2-0
Command Pass: [PROGRAM] - [DEVICE] - [OFFSET] - [-PAGE]
Press to display the previous page.
Revision History
▲ 455-3-0
Command Pass: [PROGRAM] - [DEVICE] - [OFFSET] - [▲]
Press to move the cursor up one line.
Revision History
▼ 455-4-0
Command Pass: [PROGRAM] - [DEVICE] - [OFFSET] - [▼]
Press to move the cursor down one line.
Revision History
DATA INPUT 455-5-0
Command Pass : [PROGRAM] - [DEVICE] - [OFFSET] - [DATA INPUT]
Press this key after selecting the device number. Enter offset values in Proper Data from the
numerical keypad in units of 1/1000 mm.
[Example]
If 0.1 mm is the desired offset value then input “100” from the numeric keypad.
Revision History
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-36 CP643E System Reference
SET 500-0-0
Command Pass : [SET]
Press to make other settings.
Revision History
STATUS 510-0-0
Command Pass : [SET] - [STATUS]
Press to change the machine status.
Revision History
RECOVERY 511-0-0
Command Pass : [SET] - [STATUS] - [RECOVERY]
Press to select the recovery mode.
Revision History
RECOV. NUMER 511-1-0
Command Pass : [SET] - [STATUS] - [RECOVERY] - [RECOV. NUMER]
Enter any number from 1 to 9 to set the number of recovery attempts.
Revision History
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-37 CP643E System Reference
CHANGE 511-2-0
Command Pass : [SET] - [STATUS] - [RECOVERY] - [CHANGE]
This sets the recovery mode.
Auto-recovery
Recovery automatically takes place when an error has occurred.
If the set number of times recovery is to take place is exceeded, the machine stops automatically.
Either the number of attempts set using [TIMES] or the number of recovery attempts set in status
data will display.
Error stop
Machine operation stops if an error, such as a vision processing or pick-up error occurs.
“Error stop” is displayed in yellow.
Error pass
Machine continues to operate even if an error occurs.
Error pass” is displayed in red.
Recovery will not be carried out.
The machine automatically goes into auto-recovery mode when the power is first turned on.
Revision History
PASS 512-0-0
Command Pass : [SET] - [STATUS] - [PASS]
Press to select production or pass mode.
When the machine is operating in pass mode, PASS will be displayed in light blue at P MODE.
Revision History
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-38 CP643E System Reference