CP643 系统参考.pdf - 第221页
▲ 522-2-1 Command Pass: [SET] - [MANUAL] - [VISION] - [TRACE] - [ ▲ ] Press to move the cursor upward on the vision processing screen. Revision History V1.10 and later ▼ 522-2-2 Command Pass: [SET] - [MANUAL] - [VISION] …
No. 26 Agf
This is used when the angle finder carries out detail verification. This function is used
when the angle or corner check is carried out during vision processing.
No. 30 AcqTime
This is used for the timing of acquisition when output is being sent to a parallel port.
No. 31 InsTime
This is used for the timing of inspection when output is being sent to a parallel port.
Revision History
V1.10 and later
Lead check OK
Boundary tracking display
CP643S3018
ID : 0001
NOZZLE : 10
X
Y
Q
: 00000
: 00000
: 00000
Blob processing display
(coarse positioning of part)
Angle finder display
(angular positioning
of part)
CP643S3017
ID : 0001
NOZZLE : 10
X
Y
Q
: 00000
: 00000
: 00000
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-60 CP643E System Reference
▲ 522-2-1
Command Pass: [SET] - [MANUAL] - [VISION] - [TRACE] - [▲]
Press to move the cursor upward on the vision processing screen.
Revision History
V1.10 and later
▼ 522-2-2
Command Pass: [SET] - [MANUAL] - [VISION] - [TRACE] - [▼]
Press to move the cursor downward on the vision processing screen.
Revision History
V1.10 and later
ON / OFF 522-2-3
Command Pass: [SET] - [MANUAL] - [VISION] - [TRACE] - [ON / OFF]
Press to select or cancel the item identified by the cursor.
Revision History
V1.10 and later
CLEAR 522-2-4
Command Pass: [SET] - [MANUAL] - [VISION] - [TRACE] - [CLEAR]
Press to cancel all of the trace mode settings.
Revision Hisotry
V1.10 and later
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-61 CP643E System Reference
ADJUST 522-3-0
Command Pass: [SET] - [MANUAL] - [VISION] - [ADJUSTMENT]
Commands related to camera adjustment are grouped together under the [ADJUSTMENT]
command.
Revision History
V1.10 and later
GET ACQ 522-3-1
Command Pass: [SET] - [MANUAL] - [VISION] - [ADJUSTMENT] - [GET ACQ.]
The [GET ACQ.] command can be used to adjust the camera focus and image brightness, and to
verify the status of an acquired image.
Revision History
V1.10 and later
GET ACQ 522-3-1-1
Command Pass: [SET] - [MANUAL] - [VISION] - [ADJUSTMENT] - [GET ACQ.] - [GET ACQ]
This command is used to acquire an image. The camera and light source can also be set from this
command.
Revision History
V1.10 and later
▲ / ▼ 522-3-1-1-3-1/2
Command Pass: [SET] - [MANUAL] - [VISION] - [ADJUSTMENT] - [GET ACQ.] - [GET ACQ]
[CHANGE] - [▲ / ▼]
This command is used to select the camera or light source type.
Revision History
V1.10 and later
Part 3 Chapter 3 Command Descriptions
Edition 1.0 3-3-62 CP643E System Reference