CP643 系统参考.pdf - 第348页

Notes: Part 5 Chapter 1 Errors and Countermeasures Edition 1.0 5-1-20 CP643E System Reference

1.4 Alarms Which Prevent RETURN and Shut-down

Vision System Alarm

[Cause]: The vision processing system is hung.

[Remedy]: Reboot the machine. If it appears to reboot normally, survey the situation

before proceeding. If it does not reboot normally, and the alarm occurs

again, the vision processing board is probably defective.

Part 5 Chapter 1 Errors and Countermeasures

Edition 1.0 5-1-19 CP643E System Reference

Notes:

Part 5 Chapter 1 Errors and Countermeasures

Edition 1.0 5-1-20 CP643E System Reference

2. Other Messages

This chapter describes non error messages.

2.1 Requests to the Operator

Machine Not Zero Set

The machine is waiting for the operator to press the START button to carry out zero

setting.

Press START

The machine is waiting for the operator to press the START button.

Waiting for Reset SW

The machine is waiting for the operator to press the RESET button.

Turn Off Power

The machine is waiting for the operator to press the POWER OFF button.

D??? Supply

The feeder at the device position shown is out of parts.

D??? Check

The feeder at the device position shown has parts but they are not being picked up.

D??? unable to process

Vision processing cannot process the part picked.

Invalid Command

Data was improperly entered and must be reentered.

Outside Movement Area

Since the data that has been input has caused the axis to move outside the permissible

range of movement, the machine is waiting for the data to be reentered.

Sequence End Stop

One board has been produced, and the machine is awaiting the next command.

Production Complete

Scheduled production is complete, and the machine is awaiting the operator’s next

command.

Set Proper

Machine is waiting for Proper data to be set. Set the correct Proper data.

Measure Nozzle Centers

After nozzles have been changed or after anything else occurs which makes it possible

that nozzle center values may have changed, a request will display to carry out nozzle

center measurement

Origin not Found

Machine is waiting for the START button to be pushed so that origin position search can

be started.

Part 5 Chapter 2 Other Messages

Edition 1.0 5-2-1 CP643E System Reference