CP643 系统参考.pdf - 第36页

Using the Special Key The functions listed below can be carried out using the special function key. However, these functions can be carried out only when the main operations of the inching keys are enabled (i.e. these fu…

Inching Axis Selection Key [1]

Inching axis display: X, Y, C

Inching keys:

[←] X-axis, negative direction [→] X-axis, positive direction

[↑] Y-axis, positive direction [↓] Y-axis, negative direction

[ ] C-axis, counterclockwise direction [ ] C-axis, clockwise direction

Inching Axis Selection Key [2]

Inching axis display: D1, Z, FQ

Inching keys:

[→] D1-axis, positive direction [←] D1-axis,negative direction

[↑] Z-axis, positive direction [↓] Z-axis, negative direction

[] Fθ-axis, counterclockwise direction [ ] Fθ-axis, clockwise direction

Inching Axis Selection Key [3]

Inching axis display: D2, FRQ

Inching keys:

[→] D2-axis, positive direction [←] D2-axis,negative direction

[] FRθ-axis, counterclockwise direction [ ] FRθ-axis, clockwise direction

Inching Axis Selection Key [4]

Inching axis display: NC

Inching keys:

[ ] NC-axis, counterclockwise direction [ ] NC-axis, clockwise direction

Notes:

1. D1- and D2-axis inching is possible only when the shutter is at its UP limit position.

2. To change the inching speed, use the following command sequence to select the desired

axis, then enter the desired speed from the numeric keypad.

[SET] - [SERVO] - [SPEED] - [▲] / [▼]

3. Always verify that the axis to be moved is free of interference before performing an inching

operation.

When the XY-table is at either the loading or unloading position, there are restrictions on

the Z-axis inching direction depending on the status of the carrier and main lifter.

Part 1 Chapter 1 Machine Overview

Edition 1.1 1-1-9 CP643E System Reference

Using the Special Key

The functions listed below can be carried out using the special function key. However,

these functions can be carried out only when the main operations of the inching keys are

enabled (i.e. these functions cannot be carried out when the inching keys have been

disabled due to machine operation or Proper data measurement).

Turning the light source for the mark camera on and off.

Perform the following steps:

1. While holding down the rapid inching key [F], press axis change key [4].

2. The mark camera lamp turns on. Perform this operation again to turn the mark

camera lamp off.

Caution: Do not keep the light on for long periods of time, as the life span of the bulb will decrease.

Part 1 Chapter 1 Machine Overview

Edition 1.1 1-1-10 CP643E System Reference

(3) Numeric Keys

These keys are used to input numerical values.

a: Input keys (0 - 9, *, #, D, –)

The numerical keys are used to input numerical values such as sequence numbers or I.D.

codes.

b: Backspace key (BS)

When inputting numerical values this key is used to delete previously input values.

Press this key once to move the cursor backward a single space.

c: Carriage return key (CR)

This key is used to complete the entry of a numerical value. It may also be pressed to

take the machine out of numerical input mode.

7 8 9

4 5 6 #

1 2 3 D

0 –

(a)

(b) (c)

CP643S1012

CP643S1011

Part 1 Chapter 1 Machine Overview

Edition 1.1 1-1-11 CP643E System Reference