CP643 系统参考.pdf - 第53页
(3) Other Interruptions During Automatic Operation There are instances when the CP-643E will be interrupted during automatic operation because of one of the following two reasons. 1. If calculation of placing data does n…
(2) Cycle Stop (During Automatic Operation)
The following display appears when a cycle stop occurs.
A cycle stop occurs when an error which interrupts automatic operation has occurred
(except for the case where the CYCLE STOP switch is pressed). The machine continues
the operation until it can safely stop and the message “Waiting for Reset SW” appears
along with a brief description of the error on the machine. After the source of the
problem has been removed, press the RESET switch, and the “Press START” message
will appear.
CP643S1038
Waiting for Reset SW
D100 Resupply
1ABC
2EFG
3LMN
4OPQ
5HIJK
6AT
000
000
000
000
000
000
Skip Nozzle Tape End
CP643S1037
Part 1 Chapter 1 Machine Overview
Edition 1.1 1-1-26 CP643E System Reference
(3) Other Interruptions During Automatic Operation
There are instances when the CP-643E will be interrupted during automatic operation
because of one of the following two reasons.
1. If calculation of placing data does not finish in time
If by chance the calculation of data used in placing parts does not finish in time,
automatic operation will be interrupted until these calculations have been completed.
In this case the message "Calculating Placing Data" will display on the screen. Once
these calculations have finished, return to automatic operation and start again.
2. If vision processing does not finish in time
If vision processing is not completed in time, automatic operation will be interrupted
until processing has been completed. In such a case the message "Vision processing"
will display on the screen. Once vision processing has finished, return to automatic
operation and start again.
ST 11. N 1 D 35
Vision processing
STATUS
P Mode : Product
Recovery : 3 times
T Mode : Joint
CP643S1040
ST 11. N 1 D 35
Calculating placing data
STATUS
P Mode : Product
Recovery : 3 times
T Mode : Joint
CP643S1039
Part 1 Chapter 1 Machine Overview
Edition 1.1 1-1-27 CP643E System Reference
(4) Press START
During automatic or step operation, when the command [AUTO], [STEP] or [POSITION]
have been chosen and the machine can safely carry out the operation requested, the
“Press START” message will appear. Press the START button after ensuring the machine
can safely carry out the operation.
(5) When the Machine Cannot Run
The following display will appear when the machine cannot start its next function.
When the problem displayed has been fixed the “Press START” message will appear.
Pressing the RETURN command key will restore the former situation without solving
the problem.
(6) Device Table Information in Device Change Mode
During device change mode operation when the feeder runs out of parts, the original
table will change and a display like the one below will be displayed. This display will
not disappear until parts have been set and the program has been changed.
CP643S1043
Producing ...
D000 supply
1ABC
2EFG
3LMN
4OPQ
5HIJK
6AT
000
000
000
000
000
000
Skip Nozzle Tape End
CP643S1042
Front Safety Door Open
1ABC
2EF
3HIJ
4T
5OPQ
6BC
000
000
000
000
000
000
Skip Nozzle Tape End
CP643S1041
Press START
1ABC
2EFGHI
3DEF
4IJK
5LM
6AB
000
000
000
000
000
000
Skip Nozzle Tape End
Part 1 Chapter 1 Machine Overview
Edition 1.1 1-1-28 CP643E System Reference