YV180X_Ope_E.pdf - 第173页
5 -97 EPD8013110 Operation Chapter 5 5 Creating the PCB data 6.2.1 Normal PCB origin position setting On standard machines with the front conveyor rail fixed, the center of the fix ed locate pin is specified as X=0.00, Y…
5
-96
EPD8013110
Operation
Chapter 5
5
Creating the PCB data
6.2 PCB origin
The reference point for the XY coordinates on a PCB is called the PCB
origin. The PCB origin is specified by the “PCB Origin” parameter in the
PCB Information.
The PCB origin must always be set since the PCB mark positions, compo-
nent mounting positions and the block repeat positions (refer to Chapter 6)
are specified by their coordinates relative to the PCB origin.
PCB origin
23541-C0-00
Mark position
Component
mounting positio
n
Block repeat
PCB
origin
5
-97
EPD8013110
Operation
Chapter 5
5
Creating the PCB data
6.2.1 Normal PCB origin position setting
On standard machines with the front conveyor rail fixed, the center of the
fixed locate pin is specified as X=0.00, Y=0.00, which is 5mm (X and Y)
away from the forward corner of the PCB on the front conveyor rail side.
The PCB origin is normally set to the same position as the center of the
fixed locate pin.
In this case, enter “0.00” in the “X/X1” and “Y/Y1” columns of the PCB
Origin parameter on the PCB Info. screen.
PCB origin
23542-C0-00
5mm
5mm
X
Y
5mm
5mm
5mm
5mm
5mm
5mm
X
Y
X
Y
X
Y
Direction of PCB flow Direction of PCB flow
Front conveyor rail fixed
Direction of PCB flow Direction of PCB flow
Rear conveyor rail fixed
5
-98
EPD8013110
Operation
Chapter 5
5
Creating the PCB data
6.2.2 Setting the PCB origin at a position other
than the locate pin
When setting the PCB origin at a position other than the locate pin as
shown below, enter the XY coordinates relative to the locate pin position in
the “X/X1” and “Y/Y1” columns of the PCB Origin parameter.
Setting the PCB origin at a position other than the locate pin
23543-C0-00
5mm
5mm
5mm5mm
X
Y
Direction of PCB flow
When setting the PCB
origin at point A, enter
“X=5.00” and Y=5.00.
A
Setting the PCB origin at the corner of the PCB
23544-C0-00
5mm
5mm
X
Y
Direction of PCB flow
When setting the PCB origin at
the corner of a PCB in right-to-
left flow (with the front rail fixed),
enter “X=-5.00” and Y=-5.00.